Progressive DM-01-2 User manual

1
2
3
4
10
10
M6x20MM
3x3mm
1. Tube Cover (x1)
2. Monitor Plate (x1)
3. Lock Collar (x1)
4. Tube (x1)
5. Cable Cover (x1)
6. Bottom Support (x1)
7. Knob (x1)
8. Anti-Slip Rubber (x2)
9. Cable Hooks (x4)
10. Joint Cover (x4)
Fitting the Bottom Support (6) onto the desktop
Select the appropriate
mounting holes according
to the thickness of your
tabletop
Install Monitor Plate (2) and Lock Collar (3)
Ensure the Lock Collar (3) is
fully tightened using the 3X3
allen wrench (F) before
attaching monitors.
Compatible with 0.80” to
4.00” thick tabletops
WARNING
(x8) (x8) (x3) (x2)
Tools Needed
Parts List
STEP 1
STEP 2
22 lb
17” - 30”
DM-01-2
Installation Manual
For more information or installation assitance,
contact our customer support team.
1-800-828-9414
[email protected]
E(x16) F(x1) G(x1) H(x1)
3x3MM
G
G
F
3x3mm
F
G

This product contains small items that could be a choking hazard if swallowed. Keep these items away from young children.
Please ensure all instructions are read and completely understood before attempting installation. If you are unsure of any part of this installation,
please contact a proferssional installer for assistance.
The desk or mounting surface must be capable of supporting the combined weight of the Monitor Stand and monitors otherwise the structure must be reinforced.
To ensure optimal performance, check for any loose screws every two months.
This product was designed to be installed onto a desktop. Before installing, make sure the mount will support the combined load of the mount and display.
Never exceed the maximum load capacity of 22 lb or this may result in product failure or personal injury.
This product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury.
Attaching Monitor to the Monitor Plate (2)
Adjusting the monitors and installing cables
Select Screw (A or B) depending on Monitor screw
requirements. Use more Washers (E) if needed to
ensure screws are sufficiently tight or once Monitor Plate
(2) is installed.
Adjust the tilt of the monitor using the
provided 5X5 Allen Key (H)
STEP 3
STEP 4
H
H