Randolph Morris Kally RMWZ8302-S User manual

Single Post Installation Guide
Technical Parameters:
•Recommended Water Pressure: 30→70 PSI
•Recommended Hot Water Temperature: 100 °F →120 °F
•Highest Hot Water Temperature: 170 °F
•Maximum Hole Size: 1-3/8”(35 mm)
•Maximum Thickness: 1-3/16” (30 mm)
Required Tools:
Please Note:
•NOTE: As with all Randolph Morris products, it is recommended that a licensed plumber or contractor install this
item to maintain warranty.
•The inlet pipe cannot be bent excessively. (Figure 1)
•The inlet pipe cannot be twisted excessively. (Figure 2)
•The maximum thickness of the mounting plate is 1-3/16” (30 mm). (Figure 3)
•Left is hot, Right is cold. (Figure 4)
Parts List:

Installation Steps
1. Please flush the water pipe for at least 2 mins
before installation to ensure that there are no
impurities. Hot and Cold Water Suppliers should
come from an angle outward
2. Install the O Ring (7) to the bottom of the
faucet (1). Insert the inlet hose (2) into the
main body of the faucet (1) according to the red
and blue mark and tighten it.
3. Put the gasket (3) (a is up & b is down) into the
threaded pipe and install the plastic nut in the
thread tube (4) and tighten, to ensure that the
faucet does not swing rotationally.
4. Insert the pull tube directly into the plastic
connector under the tap (1)

5. Press the gravity ball (5) marked “open” button to
open the gravity ball (5), lock it to the bottom of
the drawing tube (as shown).
6. Connect the inlet pipe (2) to the angle valve.
Open the angle valve and check for leaks on all
connections.
Operation and Maintenance
Modern bathroom faucets, kitchen faucet, and shower products are made of different materials to meet the design
and functionality of the market
•Clean with a soft cloth or a sponge and soapy water.
•Rinse thoroughly and wipe dry; drying the fixture immediately after use helps prevent lime deposits from
forming.
•To protect the finish, do not use abrasive agents, polish abrasives or acid-containing harsh cleaners.