Rejuvenation RICHMOND 27in Vanity User manual

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 1/14 

RICHMOND 27in Vanity

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 2/14

BEFORE YOU BEGIN
Marble top is both heavy, and until installed, fragile. Please have a helper and use caution when moving marble
top.

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 3/14

BEFORE YOU BEGIN (cont’d)
Make sure to observe all local plumbing codes.
Prior to installation, unpack and inspect both the console and marble top and porcelain lavatory for damage.
Locate the installation parts package and put in a safe place—you will need this for installation.
Do not dispose of any packaging or contents of the shipping carton until assembly is completed to avoid
accidentally discarding small parts or hardware.
Installation assumes that walls and floor are plumb and level. Please make appropriate adjustments for other
conditions.
Remove any molding that may prevent the console from being set flush to the finished wall.
TOOLS AND MATERIALS
Tape measure
Pencil
Level
Drill with appropriate drill and driver bits
Eye protection
Clear 100% silicone adhesive caulk
Screws for securing vanity base to building framing.
CARE INSTRUCTIONS
Dust often using a clean, soft, dry and lint-free cloth.
Immediately blot up spills, then wipe with a clean, damp cloth.
We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered
finish.
Hardware may loosen over time. Periodically check to make sure all connections are tight. Re-tighten if
necessary.

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 4/14 


Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 5/14 

REMOVE THE DRAWERS.
Mark locations and set aside in a safe place.

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 6/14 

POSITION THE VANITY BASE
Position the vanity base in the desired location against the finished wall. Remove baseboard
as needed.
Verify that the vanity base is level: front to back and side to side. Adjust the levelers at the
bottom of the legs as necessary.






ATTACH THE VANITY BASE TO THE WALL
Locate two wall studs to secure the vanity base. Make sure to avoid plumbing.
Drill pilot holes through the back and into the studs. If necessary, provide shims between
vanity and back rail so the vanity base is not distorted.
Using screws (not supplied), secure the vanity base to the wall.
Do not use wall anchors.

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 7/14 

IF INSTALLING OPTIONAL CONCRETE TOP, REMOVE PIECES OF WOOD SHOWN

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 8/14

ATTACH THE UNDERMOUNT SINK TO THE STONE TOP
Skip these steps if installing optional CONCRETE top

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 9/14

ATTACH THE UNDERMOUNT SINK TO THE TOP (CONT’D)
Skip these steps if installing optional CONCRETE top

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 10/14 

ATTACH TOP TO VANITY BASE
Marble top shown
INSTALL BACKSPLASH
Marble top shown
Apply a bead of caulk on the BACK of the backsplash.
Press against wall and align evenly side to side.
Hold in place with blue painter’s tape until caulk cures.

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 11/14 

CONNECT FAUCETS AND PLUMBING
Keep these clearances in mind when routing plumbing

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 12/14 

REINSTALL DRAWERS
Make sure drawers go back to original location
ADJUST DRAWERS
to create even gaps around them if necessary

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 13/14 

DIMENSIONS

Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20 www.rejuvenation.com 14/14
