Reliant ADC V520 User manual

REV 11/15
Home Automation by Reliant
Quick Start Guide
Video Camera
models ADC V520, ADC V520IR or ADC V620PT

2
Reliant |Quick Start Guide | Video Camera Quick Start Guide | Video Camera 3 Reliant |
Model ADC V520/ADC V520IR
Model ADC V620PT
Step 2: Synching your camera with the network
Log into the Reliant Connect web portal at reliant.com/
connectlogin, click Video > Video Device Settings > Add Video
Device and follow the instructions in the EZInstall™Camera
Setup Wizard.
Your Wi-Fi-enabled video camera gives you the
peace of mind of a live video feed of your home,
accessible from your mobile device. Use this guide
to install your camera and add it to your system for
full network accessibility.
Step 3: Installing your camera
1After adding the camera to your network,
disconnect your video camera from the
Ethernet cable.
Questions? Visit support at
reliant.com/connectsupport or
give us a call at 1.844.295.5556
Get the whole picture from
anywhere, anytime.
Connect the video camera to your Internet router with the
supplied Ethernet cable, and then plug it into a power source.
2Placeyourcameraonaatsurfaceinthe
desired location or mount it using the
manufacturer’s instructions that came with
your camera, and plug it in.
Place the camera within ample reach of an
electrical outlet so that the power cord doesn’t
cause the camera to move on its mount.
To nish the set-up process, including
detailed instructions, optimizing camera
settings and setting up recording
schedules, log into the Reliant Connect
web portal at www.reliant.com/
connectlogin.
Step 1: Adding your camera to the network
NOTE: The Ethernet cable must be connected to the camera before power
is connected.

Home Automation products and services are provided by NRG Connected Home LLC d/b/a Reliant. Terms and conditions apply. For complete terms and conditions,
visit reliant.com/connectterms. Reliant is a service mark of Reliant Energy Retail Holdings, LLC. © 2015 NRG Energy, Inc. All rights reserved. 197889