Remo+ ROTOTOM User manual
ROTOTOM ASSEMBLY INSTRUCTIONS
Turn the long carriage bolt clockwise unl it makes contact with the boom insert.
Place stand and lter in
the upright posion.
Slide the short carriage bolt into the Rototrac approximately to the midway point. Tighten the AD10 adaptor plate to the
Rototrac using the washer, nut, and included wrench. Place Rototrac assembly on top of the Ratchet Block Tilter.
Tension Rod
Ratchet Block Tilter
Rototrac
AD10 Adaptor Plate
Short Carriage
Bolt Notch
Tighten AD10 & Rototrac to the Ratchet Block
with the included Dum Key.
Slide the 10” Rototom Assembly into the
Rototrac with the washer on top.
Tighten the Handle to secure the
10” Rototom to the Rototrac. Re-
peat for the 6” & 8” Rototoms,
sliding them into the Rototrac from
the le side of the stand.
Rotate the enre Rototom assembly
Clockwise to increase the pitch.
Rotate the enre Rototom assembly
Counter Clockwise to decrease the pitch.
6” Rototom 8” Rototom 10” Rototom
Tension Rods should be threaded all the way through and even on
the boom casng
For more informaon visit: remo.com
Table of contents
