RIGd Supply UltraPlate User manual
INSTALLATION GUIDE
UltraPlate™ Mounting System
Congratulations on your UltraPlate! You’re only a few steps away from hitting the trail.
RIGd Supply 1533 W Orangewood Ave, Orange, CA 92868 | [email protected] | 949-424-3057
Installing the RIGd UltraPlate™ to the UltraSwing™
1. Bolt mounting brackets to the Ultraplate as shown with bracket arms facing downward
(Figure 1)
2. Install bracket mounting bolts so that the back of the bolts face up towards the brackets. DO
NOT FULLY TIGHTEN BOLTS, you will need to be able to slide brackets for final adjustment.
(Figure 2)
3. Place UltraPlate on to UltraSwing and insert mounting bolts. Note, if wheel plate is mounted
in second-from-the-top hole position the UltraPlate will be very close to your wheel mounting
plate bolts, however, it can still be mounted with some touching between bolts. For easier
fitment you can also change the position of your wheel plate. (Figure 3)
4. Once Ultraplate bolts are in place, align and tighten. Note, small center alignment bolts can be
tightened with a wrench from the side of the UltraPlate. (Figure 4)
Figure 1
Figure 2
2
Figure 3
Note: If wheel plate is mounted in
second-from-the-top hole position the
UltraPlate will be very close to your wheel
mounting plate bolts, however, it can still be
mounted with some rubbing between bolts.
For easier fitment you can also change the
position of your wheel plate.
Tighten Alignment Bolts
Note: Bolts can be accessed from the
side of the plate.
Figure 4
3
Congratulations, your UltraPlate is now installed!
4
Table of contents
