Sapido BRF70n User manual
http://www.sapido.com.tw Quick Installation Guide v1.0.0
2
FCC CAUTION................................................................................................................................................... 3
1INTRODUCTION............................................................................................................................ 5
1.1 LED INDICATORS ....................................................................................... 6
1.2 PRODUCT APPEARANCE ................................................................................ 7
2INSTALLATION DIAGRAM ......................................................................................................... 7
3SETTING .......................................................................................................................................... 9
3.1 USING LAPTOP........................................................................................... 9
3.2 USING IPHONE/IPAD .................................................................................. 13
3.3 USING ANDROID MOBILE DEVICE ................................................................... 17
http://www.sapido.com.tw Quick Installation Guide v1.0.0
3
FCC Caution
FCC Part 15.19 Caution:
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may
cause undesired operation
2. This device and its antenna(s) must not be co-located or operating in conjunction with
any other antenna or transmitter.
3. Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between
the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
FCC Statement in User’s Manual (for calss B)
FCC Section 15.105
“Federal Communications Commission (FCC) Statement”
This equipment has been tested and found to comply with the limits for a lass B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
http://www.sapido.com.tw Quick Installation Guide v1.0.0
4
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
CE Statement of Conformity
Our product has been tested in typical configuration by Ecom Sertech Corp and was found to
comply with the essential requirement of “Council Directive on the Approximation of the Laws of
the Member States relating to Electromagnetic Compatibility” (89/336/EEC; 92/31/EEC; 93/68/EEC)
http://www.sapido.com.tw/ Quick Installation Guide v1.0.0
5
1Introduction
BRF70n is an easy-to-setup and wireless device for various application and environment,
especially for hotel, office, warehouse, hot-spot, and etc...
The mail features of BRF70n:
International Award winning; built-in adaptor; compact and portable: INOVA
2012 Croatia Award. One of the smallest foddable built-in adaptor both available for
AC/DC power charges. Easy carrying.
One of the smallest foddable built-in adaptors; easy carrying along: One of the
smallest built-in foldable adaptors both available for AC/DC power charges. Ideal
for trvelers. Micro USB supports multiple power charges (e.g. laptop or car charger)
without limits.
Power-saving Green AP technology and MIT quality assurance: Meets the
IEEE802.3az standard and uses Green access point (AP) technology to reduce power
consumption by up up to 80%. MIT quality assurance standards.
Provides a portable access point (AP) while travelling: Use this portable router to
easily and quickly convert any wired connection (in the hotel or otherwise) into a
Wi-Fi signal.
Supports Wi-FiAPsignal extension and one touch WPS encryption: Wi-Fi AP
hardware switch extends the existing wireless network. The best Wi-Fi range
extender. One touch WPS button for wireless range extension to eliminate dead spot
between floors.
Flexible, smart, and convenient: Multiple modes allow users to act as a standard
router, to connect to public hotspots, to act as an access point (AP), or to extend a
wireless network extender (Wi-FIAP). Automatic network connection technology.
Plug and play. Firmware updates.
http://www.sapido.com.tw Quick Installation Guide v1.0.0
6
1.1 LED Indicators
LED
Function
Color
Status
Description
Power indicator Green On Power is being applied to this product
Status / WPS
activity Green
On System is ready to work
Blinking
30ms Reset is in progress
Blinking
120ms WPS function in progress
Wireless activity Green
On Wireless is connected
Blinking
120ms Wireless Tx/Rx activity
WAN port activity
Green
On 100Mbps Ethernet is connected
Blinking
30ms 100Mbps Ethernet Tx/Rx activity
Green
On 10Mbps Ethernet is connected
Blinking
120ms 10Mbps Ethernet Tx/Rx activity
LAN port activity
Green
On 100Mbps Ethernet is connected
Blinking
30ms 100Mbps Ethernet Tx/Rx activity
Green
On 10Mbps Ethernet is connected
Blinking
120ms 10Mbps Ethernet Tx/Rx activity
http://www.sapido.com.tw Quick Installation Guide v1.0.0
9
3Setting
3.1 Using Laptop
Step 1. Set up the router using laptop. Connect to BRF70n through wireless.
Step 2. Open the web browser. Sapido router will detect the Internet connection type
and help users enter into the setting page automatically.
http://www.sapido.com.tw Quick Installation Guide v1.0.0
10
3.1.1 Internet Connection Type
Sapido router will detect the Internet connection type and help users enter into
the setting page automatically.
3.1.1.1 ADSL/xDSL Modem
Step 1. Open the web browser. Sapido router will detect the Internet
connection type and help users enter into the setting page
automatically. Please enter in the username and password for
ADSL/xDSL connection. Also, we recommend users set up the
wireless security.
Step 2. Click Apply. Please do not power off the router or disconnect
the Internet while counting down.
Step 3. After the connection is successful, please download Sapido
Cloud to complete the setting.
3.1.1.2 Cable Modem
Step 1. Open the web browser. Sapido router will detect the Internet
connection type and help users enter into the setting page
http://www.sapido.com.tw Quick Installation Guide v1.0.0
11
automatically.
Step 2. Click Apply. Please do not power off the router or disconnect
the Internet while counting down.
Step 3. After the connection is successful, please download Sapido
Cloud to complete the setting.
3.1.1.3 Static IPAddress
Step 1. Open the web browser. Sapido router will detect the Internet
connection type and help users enter into the setting page
automatically.
Step 2. Enter in the IP address, subnet mask, gateway, and DNS for
Internet connection. (Please use the correct connection data that ISP
provided)
http://www.sapido.com.tw Quick Installation Guide v1.0.0
13
3.2 Using iPhone/iPad
Step 1. Set up the router using iPhone/iPad. Go to Settings → Wi-Fi → Enable Wi-Fi
→ Connect to BRF70n through wireless.
Step 2. Open the web browser. Sapido router will detect the Internet connection type
and help users enter into the setting page automatically.
http://www.sapido.com.tw Quick Installation Guide v1.0.0
14
3.2.1 Internet Connection Type
Sapido router will detect the Internet connection type and help users enter into
the setting page automatically.
3.2.1.1 ADSL/xDSL Modem
Step 1. Open the web browser. Sapido router will detect the Internet
connection type and help users enter into the setting page
automatically. Please enter in the username and password for
ADSL/xDSL connection. Also, we recommend users set up the
wireless security.
Step 2. Click Apply. Please do not power off the router or disconnect
the Internet while counting down.
Step 3. After the connection is successful, please download Sapido
Cloud to complete the setting.
3.2.1.2 Cable Modem
Step 1. Open the web browser. Sapido router will detect the Internet
connection type and help users enter into the setting page
http://www.sapido.com.tw Quick Installation Guide v1.0.0
15
automatically.
Step 2. Click Apply. Please do not power off the router or disconnect
the Internet while counting down.
Step 3. After the connection is successful, please download Sapido
Cloud to complete the setting.
3.2.1.3 Static IPAddress
Step 1. Open the web browser. Sapido router will detect the Internet
connection type and help users enter into the setting page
automatically.
Step 2. Enter in the IP address, subnet mask, gateway, and DNS for
Internet connection. (Please use the correct connection data that ISP
provided)
http://www.sapido.com.tw Quick Installation Guide v1.0.0
17
3.3 Using Android Mobile Device
Step 1. Set up the router using Android mobile device (smartphone/tablet). Go to
Settings → Wireless & Networks → Enable Wi-Fi → Wi-Fi settings →
Connect to BRF70n through wireless.
Step 2. Open the web browser. Sapido router will detect the Internet connection type
and help users enter into the setting page automatically.
http://www.sapido.com.tw Quick Installation Guide v1.0.0
18
3.3.1 Internet Connection Type
Sapido router will detect the Internet connection type and help users enter into
the setting page automatically.
3.3.1.1 ADSL/xDSL Modem
Step 1. Open the web browser. Sapido router will detect the Internet
connection type and help users enter into the setting page
automatically. Please enter in the username and password for
ADSL/xDSL connection. Also, we recommend users set up the
wireless security.
Step 2. Click Apply. Please do not power off the router or disconnect
the Internet while counting down.
Step 3. After the connection is successful, please download Sapido
Cloud to complete the setting.
http://www.sapido.com.tw Quick Installation Guide v1.0.0
19
3.3.1.2 Cable Modem
Step 1. Open the web browser. Sapido router will detect the Internet
connection type and help users enter into the setting page
automatically.
Step 2. Click Apply. Please do not power off the router or disconnect
the Internet while counting down.
Step 3. After the connection is successful, please download Sapido
Cloud to complete the setting.
http://www.sapido.com.tw Quick Installation Guide v1.0.0
20
3.3.1.3 Static IPAddress
Step 1. Open the web browser. Sapido router will detect the Internet
connection type and help users enter into the setting page
automatically.
Step 2. Enter in the IP address, subnet mask, gateway, and DNS for
Internet connection. (Please use the correct connection data that ISP
provided)
Step 3. Click Apply. Please do not power off the router or disconnect
the Internet while counting down.
Step 4. After the connection is successful, please download Sapido
Cloud to complete the setting.
Table of contents