5-13-2020 3PN 23355
3) Put the bottom plate on, by sliding it onto the
bottom ends of both feet. 4) Now using six long screws, fix the bottom plate
to the feet from underneath, using the 6 pre-drilled
holes in the bottom plate. Make sure the heads of
the screw don’t stand out, tighten them enough.
5) Now fix the bottom plate to the back plate using
three long screws. 6) Stand the structure up. Fix the pyramid feet to
the back plate using two long screws on each
side. Use the pre-drilled holes as guides. Make
sure to hold both sides of the support foot in place,
so the screw goes through both sides of the end of
the support foot and through the back plate