Schwank JP-2300-MK User manual

GP-MMAK-CX-04A
2100/2300 Mounting Arm Kit Manual
AUG 2021
RL: 1A
Tel [phone] | www.schwankgroup.com
JP-2300-MK ARM WALL MOUNTING KIT
MOUNTING ARM AND HEATER BRACKET
HEATER BRACKET FASTENS TO MOUNTING ARM
WITH 2 EACH NUTS & BOLTS SUPPLIED
WARNING: Ensure that anchoring to the structure (field sup-
plied anchor hardware) is of sufficient strength, in-
tegrity and workmanship, to adequately support the
weight of the heater and any other potential loads
such as snow build up and wind.
• See next page for assembly of heater bracket to mounting arm for desired heater
orientation at horizontal or 30° angle
• Mounting arm dimensions on page 3
ALLOWS MOUNTING OF HEATER:
• 27.5” FROM MOUNTING SURFACE
• EITHER HORIZONTAL
• OR AT 30° ANGLE (MAXIMUM) Six anchor
points

GP-MMAK-CX-04A
2100/2300 Mounting Arm Kit Manual
AUG 2021
RL: 1A
Tel [phone] | www.schwankgroup.com
Assemble Mounting Bracket
to Mounting Arm using bolts
and nuts supplied:
• Align the anchor holes in
the heater bracket and the
mounting arm, and insert a
bolt
• Finger tighten nut on to
bolt to allow rotation of the
heater bracket
• Align the desired mounting
angle holes in the heater
bracket to the outermost
holes in the mounting arm
• Insert second bolt and fin-
ger tighten ONLY nut to
bolt
• Horizontal mount
• 30° Angle mount
IMPORTANT
• Install heater to mount-
ing bracket (4 studs /
nuts) BEFORE tightening
nuts on bolts to mounting
arm with wrench
Using pairs of holes in the heater
bracket allows heater orientation:
• Horizontal
• Angled at 30°
(MAXIMUM angle mount)
Anchor holes
(bracket pivot
point)
Studs at top of heater to mounting bracket
NOTE: MOUNT HEATER AT MAXIMUM 30° ANGLE