J.Burrows Elite MA300 User manual

Item No.: Elite MA300
GAS SPRING MONITOR ARM WITH USB HUB
2.5-8.5kg
1 / 12
INSTRUCTION MANUAL

VESA plate
50cm Type-C cable
Base
3x3 allen key
11
12
13
14 Instruction manual
2 / 12

Preparation before installing monitor
1. Make sure there are VESA holes 100x100mm or 75x75mm in the
monitor. If not, the mount cannot be installed.
2. Remove the original fixed base of monitor. Be careful not to scratch
the screen.
75x75 or 100x100
75x75 or 100x100
3 / 12

Tabletops only. This clamp cannot be
mounted on other tabletops without risk
of the clamp or parts falling.
Caution
Option 01: Clamp
4 / 12

Option 2: Grommet
5 / 12

Connect the upper and lower arm support to the base
6 / 12
Tightent it with a 3x3 allen key (11)
after inserting

Attaching the monitor to the plate
7 / 12
monitor
Use washers (D) if screw holes in
monitor are not deep enough to
ensure the monitor and VESA plate
are tightly secured
Tighten the screw with the cross end of the allen key (F)
Tighten

Hang the monitor from top to
bottom on the connection plate
and make sure it is attached firmly.
Install the monitor to the arm support
8 / 12

If the monitor cannot stop at any height, please
monitor is up and “+” direction when
it is down.
9 / 12
Adjust the monitor

Type-C Host（PC）
10 / 12
Connect cables

Use both hands to pull apart the cable holder to remove.
Once cords are in place, put the cable holder back in place.
holder,
11 / 12
Using cord management

Officeworks Ltd warrants that this product will be free from defects and work as intended for three
years from the date of purchase by the original customer.
If the product has any defects or does not work as specified during the Warranty Period, Officeworks
will, at its election and at its expense, repair or replace the product.
This warranty does not apply:
• to cosmetic damage;
• to damage caused by consumables used in connection with the product (such as batteries);
• where the product has not been used in accordance with all provided instructions;
• to damage arising from fair wear and tear;
• where the product has not been subject to reasonable use;
• where the product has been intentionally or negligently damaged; and/or
• if the customer has attempted to repair the product.
To make a claim under this warranty, please return your product with your receipt or proof of purchase
to your nearest Officeworks store or contact 1300 633 423.
This warranty is provided in addition to any rights you may be entitled to under the Competition &
Consumer Act 2010. Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or refund for a major failure and
compensation for any other reasonably foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does
not amount to a major failure.
WARNING
This product was designed to be installed on desk.Before installing, make sure the mount will
support the combined load of the equipment and hardware.Never exceed the maximum load
capacity 8.5 kg, or else it may result in product failure or personal injury.
Note:this product is intended for indoor use only.Use of this product outdoors could lead to
product fallure or personal injury.
12 / 12