Scout GPS/GLONASS/GSM MT-865 ONE User manual

Quick start guide for tracker GPS/GLONASS/GSM МТ-865 ONE
1. General information
This quick start guide applies to the car tracker GPS/GLONASS/GSM МТ-865 ONE
(hereinafter referred to as the "tracker")
Table 1. Specifications
Parameter
Value
Comment
Power
Supply voltage
9 ÷ 36 В
Average current consumption (24V)
до 125 мА
online monitoring
до 45 мА
standby
Built-in battery capacity
250 mAh
supplied as an option
Built-in battery life time
Up to 1 hour
depends on settings and
ambient temperature
Operating conditions
Working temperature range
-40 ÷ +85 °С
with data transfer to the
server
-10 ÷ +65 °С
working from backup battery
0 ÷ +45 °С
charge battery protection
Case protection degree
IP40
Mass and overall characteristics
Terminal weight
300 grams
Case size
88х72х24 mm
Built-in sensors and modules
The amount of non-volatile memory
2 Mbyte
Number of entries in the telemetry log
Up to 200 000
Accelerometer
+
Traffic encryption function
+
Ports and interfaces
Inputs
4
For reading digital, analog,
frequency and counter value
Outputs
1
Open collector type, switching
voltage up to 65 V, current up
to 200 mA
USB
+
for tracker settings
management
2. Indication
On the tracker board there are three LED indicators visible from the outside of the housing to
control the operation of the tracker. The purpose of the indicators is shown in Figure 1 and
described in Table 2
GPS
blue
GSM
green
STATUS
red
Figure 1. Purpose of indicators
Table 2.
Indicator status
Tracker status
Blue GPS indicator
Off
Off/ Power saving mode
Flashing blue 1 time per second - - - - -
Searching and capturing GPS
signals
Flashing blue once every 5 seconds - - - -
Position detected
GSM indicator green
Off
Off / Power saving mode
Flashing green 1 time per second - - - - -
Search and registration in the GSM
network
Flashing green once every 5 seconds - - - -
Registered in the GSM network
Glows green constantly —————
There is an exchange of information
with one of the Servers
STATUS indicator red
Off
No external power / in
"Hibernation" mode
Glows red constantly —————
There is external power
Flashes red once every 5 seconds - - -
Power saving mode
Flashes red 1 time per second - - - - -
USB powered

3. Diagram of the interface connector
Scheme of the interface connector (view from the side of the tracker contacts) (Figure 2):
key
Figure 2. MT-865 ONE Interface Connector
Table 3.
№ pin
Wire color
Function
1
Black
Power GND ("-")
2
-
-
3
-
-
4
-
Universal port 0 (P0+ D, F, C, A)
5
Yellow
Universal port 2 (P2+ D, F, C, A)
6
-
Output P4
7
Red
Power VCC ("+")
8
-
-
9
-
-
10
-
Universal port 1 (P1+ D, F, C, A)
11
-
Universal port 3 (P3- D, F, C)
12
-
-
The mounting kit includes 12-pin mating cable with 3 wires (black, red, yellow) installed
according to Table 3 and 2 wires with contacts.
4. Installation requirements
• All actions during installation must be carried out ONLY WITH THE POWER OFF!
• Do not install the Terminal in places subject to increased heat - this may
lead to failure of the backup battery!
• Before installation, you must install a SIM card
5.Preliminary setting of the Terminal
The tracker can be configured in several ways: using the SCOUT-Configurator software,
connecting to the tracker via USB, via the Internet or using SMS commands.
To configure the tracker, you will need the SCOUT-Configurator software. This software requires
a computer with Windows 10 operating system or newer.
SCOUT-Configurator, Documentation and drivers you can download at this link
or QR code https://8xx.scout-gps.ru/mt865one
Before installation, the following minimum set of parameters must be configured:
Connection settings to
the telematics Server:
GPRS settings:
Port settings:
−Server address,
−Port,
−Server communication
protocol
−login,
−password,
−APN (access point)
−make settings depending on the
connected sensors and devices
6. Typical installation scheme