Seastar Solutions HA5417 User manual

INSTALLATION INSTRUCTIONS
Copy Part# 6 628, Rev. I, 12/2013 Page 1 of 2
© 1999 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6 Fax: [phone] Web: www.seastarsolutions.com
1 766815 1 Mounting Bezel
2 18562 Carriage Bolts
1/ ”x 3-1/2”
3 766723 1 Rubber Seal
067528 8 Washer 1/ ” Flat
ITEM PART QTY DESCRIPTION
3
4
HELM PUMP
• Drill m unting h les and pr visi n f r helm using the template
n page 2.
• Assemble the m unting bezel (item 1) with the carriage b lts
(item 2) and the rubber seal (item 3) acc rding t the diagram.
• Secure the assembly t the m unting surface using the washers
(item 4) and the nuts (item 5). T rque t 75in-Ib (8.67Nm).
•
Insert the helm pump fr m behind the dash thr ugh the h le in the
m unting surface and secure using the m unting plate (item 6)
and remaining nuts (item 5). T rque t 75in-Ib (8.67Nm).
2
1
6
5
DASH
5
*5 067 2 8 Locking Nut 1/ ” NC
6 76 233 1 Anchor Plate
ITEM PART QTY DESCRIPTION
4
MOUNTING KIT HA5417
Standard Helm – Round Bezel Back Mount
Item 5: Torque to
75in-lb (8.67Nm).
NOTICE
*
**
Figure A.
For helm pumps produced after
October 2008 use Mounting Kit
Part # HA54 8.
NOTICE

INSTALLATION INSTRUCTIONS
Copy Part# 6 628, Rev. I, 12/2013 Page 2 of 2
© 1999 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6 Fax: [phone] Web: www.seastarsolutions.com
1. Tape template t dashb ard.
2. Bef re drilling h les, check that the p siti n f the helm will
all w unrestricted m vement f the steering wheel.
3. Drill the 4-3/8” diameter center h le and the 5/16” diameter
m unting h les, p siti ned as sh wn.
DO NOT attempt t install this helm with ut first reading the
installati n instructi ns. If installati n instructi ns are missing,
c ntact SeaStar S luti ns f r a new c py. Failing t c mply
may result in l ss f steering causing pr perty damage and/ r
pers nal injury.
If printing r ph t c pying f this template is required, please
check all measurements BEFORE y u drill any h les t ensure
that the template y u have printed is true and c rrect.
MOUNTING KIT HA5417
Standard Helm – Round Bezel Back Mount
WARNING
CAUTION
Figure B.
3-1/2" (89 mm)4 x HOLES
5/16" DIA.
(8 mm)
1 HOLE
4-3/8" DIA. (112 mm)
3-1/2" (89 mm)