Sensei LH-QC55 User manual

QUICK CLIP LENS HOODS
User Manual
LH-QC52, LH-QC55, LH-QC58, LH-QC62,
LH-QC67, LH-QC72, LH-QC77, LH-QC82

1
Thank you for choosing Sensei.
The Sensei Quick Clip Lens Hood mounts securely
to your camera lens to prevent stray light from
entering, thus eliminating glare and lens flare.
This specially-designed lens hood allows for quick
mounting with a simple press and click. The lens
hood is easy to reverse for storage or when you
want it out of the way. It rotates on the Quick Clip
lens ring for top and bottom orientation and it
minimizes damage caused by impacts.

2
Overview
Quick Clip Lens Ring Quick Clip Lens Hood
Ball Bearing
Rail
Ball
Bearings
Lens
Thread
Filter
Thread
Top
Bottom

3
Instructions
Note: For use with internal focusing lenses and non-
rotating filters. Do not use with thin filter widths,
as they may be difficult to remove. Accommodates
lenses with widest focal length of 20 mm for full
frame and 15 mm for crop sensors. Using center
pinch lens caps are recommended.
1. Remove the Quick
Clip Lens Ring from
the lens hood by
pressing on the
ring from the inside
of the hood until it
pops out.

4
2. Align the lens thread
on the Quick Clip
Lens Ring with the
thread on the front
of your cameras lens.
3. Turn the ring
clockwise until it is
securely fastened
onto the lens.

5
4. Position the Quick
Clip Lens Hood
with the label TOP
aligned with the top
of the lens.
5. Firmly press the lens
hood onto the lens
ring until it clicks into
place.
TOP
TOP

6
6. To reverse the hood,
remove it from the
ring, reverse the
orientation and press
it into place.
TOP

7
One-Year Limited Warranty
This SENSEI product is warranted to the original purchaser to be
free from defects in materials and workmanship under normal
consumer use for a period of one (1) year from the original purchase
date or thirty (30) days after replacement, whichever occurs later.
The warranty provider’s responsibility with respect to this limited
warranty shall be limited solely to repair or replacement, at the
provider’s discretion, of any product that fails during normal use of
this product in its intended manner and in its intended environment.
Inoperability of the product or part(s) shall be determined by the
warranty provider. If the product has been discontinued, the warranty
provider reserves the right to replace it with a model of equivalent
quality and function.
This warranty does not cover damage or defect caused by misuse,
neglect, accident, alteration, abuse, improper installation or
maintenance. EXCEPT AS PROVIDED HEREIN, THE WARRANTY
PROVIDER MAKES NEITHER ANY EXPRESS WARRANTIES NOR
ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE. This warranty provides you with
specific legal rights, and you may also have additional rights that
vary from state to state.

8
To obtain warranty coverage, contact the Sensei Customer Service
Department to obtain a return merchandise authorization (“RMA”)
number, and return the defective product to Sensei along with the
RMA number and proof of purchase. Shipment of the defective
product is at the purchaser’s own risk and expense.
For more information or to arrange service, visit www.madebysensei.
com or call Customer Service at 212-594-2353.
Product warranty provided by the Gradus Group.
www.gradusgroup.com
SENSEI is a registered trademark of the Gradus Group.
© 2016 Gradus Group LLC. All Rights Reserved.

SENSEI is a registered trademark of the Gradus Group.
© 2016 Gradus Group LLC. All Rights Reserved.
www.madebysensei.com
GG1