Sideline Power High Riser Lite Manual

Setup Instructions
High Riser Lite

(1)Take the tower out of the bag.
(2) Carry tower to the filming
location.
(3) Place the tower upright and
loosen the top knob.
(1) Open the tower legs.
(2) To fully open, lift tower by
the pole and press down on the
top collar to spread out legs.
(3) Extend legs as wide as
possible.
(1) Loosen the bottom knob and
slide the pole down until it hits
the ground.
(2) Tighten the top and bottom
knobs.
1
1
1
2
2
3
2
3
4
Set Up Instructions

Turn off all electronics: monitor,
camera, and joystick.
Unhook the cable from the
camera remote and
monitor.
(1) Slowly loosen the first knob
of the tower while keeping your
other hand on the pole as a
brake. (2) When the pole is
loose enough to slide down,
guide the pole all the way down
with both hands and then (3)
tighten the knob. Repeat with
each pole section until the unit is
completely lowered down.
IMPORTANT – Always have two
hands on the tower while raising
or lowering.
Now that the tower is down,
unhook the top cable
connections and strain relief and
store the cable in the backpack.
Take the pan tilt and camera off
the tower and store.
Now store the joystick, camera
remote, monitor battery, and
monitor in the hard case.
Next, take off the control plate
and store in the backpack.
Once the electronics and control
plate are off, loosen the top and
bottom leg collar knobs and
bring the legs up towards the
tower. Be sure to lock the legs
by tightening top knob.
IMPORTANT – Lower tower all
the way before unlocking the
legs.
10
Take Down Instructions