SIGLENT SSA-RMK User manual
User Manual
频谱分析仪机柜安装套件组装说明
Siglent SSA-RMK Installation Instructions
部件装配示意图 Schematic diagram
零件清单（Kit part list）：
序号 NO.
名称 Name
数量 QTY.
描述 Description
1
提手 Handle
2
2
M4*10
16
16=10+4+2
3
五金前面板 Front panel
1
4
M5*10
4
4
5
五金底板 Support panel
1
6
五金右板 Right panel
1
7
五金挡板 Metal baffle
1
8
五金左板 Left panel
1
User Manual
安装步骤 Installation steps
1、安装五金左、右板：五金左、右板对准五金底板的孔，用 4pcs M4*10 的螺钉将其固定，见图 1；
Install the left and right plates of hardware: the left and right plates of hardware are aligned with the holes of the
hardware base plate and fixed with 4pcs M4*10 screw, as shown in Figure 1；
Figure 1
User Manual
2.安装五金前面板：将五金前面板用 10pcs M4*10 的螺钉将其固定在上一步骤组装好的五金框架上，见图 2；
Install Hardware Front Panel: Fix Hardware Front Panel with 10pcs M4*10 Screw on Hardware Frame which is assembled
step by step, as shown in figure 2;
3.安装提手：通过 4pcs M5*10 螺钉，将提手固定在五金前面板上，见图 2；
Install the handle: fix the handle on the front panel By 4pcs M5*10 screws, as shown in figure 2；
Figure 2 Figure 3
4.固定仪器：用 2个固定件把仪器压紧，用 2pcs M4*10 的螺钉来固定，见图 3；
Fixed instrument: press the instrument with two fixed parts, and fix it with 2pcs M4*10 screw, as shown in figure 3;
5.装入机柜：用 4pcs M6 的螺钉配套相应的螺母（M6 螺母）将固定好的仪器的支架安装在标准 19 英寸的机柜上；
注：机架占 6U 的高度，见图 4；
Load into the cabinet: use the screws of 4pcs M6 to match the corresponding nuts (M6 nuts), and install the fixed
instruments bracket on the standard 19 inch cabinet. Note: the rack occupies the height of 6U, as shown in figure 4.
Figure 4
Table of contents
