SilverStone RMS01 User manual

Quick Installation Guide of RMS01
75 35
CHASSIS
MIN=A+38 (22" Below = 632mm)
A
EXT=300MM
38
FRONT BRACKET REAR BRACKET
Align the spring clip on chassis (inner) member of the pre-formed bayonets on
both sides of the chassis. Push back the inner member to allow the rail slide to
be fixed to the rackmount chassis. Moreover, please make sure the spring clip
installation has been completed on the rackmount chassis when finishing this step.

G11223550
4
*Bayonet on chassis shall be pre-formed as per the recommended dimension and
location.
* If there is concern for rackmount security, we have provided screws to allow further
reinforcement of the fixed rackmount chassis.
*If you need to remove the inner member from the rackmount chassis, please pull
up spring clip first and then push forward to allow the spring clip to separate from
the inner member. If you had already installed the screw in your rackmount chassis,
please remove the screws first.