
3.Make sure all the
Roto-Lock toggle feet
are retracted so that
they are tucked within
the mounting hole’s
border. Insert the
speaker into the
hole in the ceiling
(Figure 5). The Roto-
Lock system can
accommodate a ceiling
material thickness of
1-1/4” (32mm) with
the toggle foot cap
removedthesystemcan
accommodate a ceiling
material thickness of
1-7/8” (48mm).
4.When installing into
doubledrywall or other
thickerceilingmaterials,
youmayneedtoremove
part of the two-piece
toggle feet. Use a small
screwdriver to gently
releasethetwolocking
levers(Figure4).
5.Tighten the screws
on the front of the
speaker baffle. The
Roto-Lock toggle feet will
automaticallyrotateinto
position and begin
clamping the speaker
(Figure 6). When you
notice resistance on
the screws the speaker
has been clamped
successfully.
I M P O R T A N T : ALWAYS USE LOW TORQUE SETTINGS;
NEVER OVER-TIGHTEN.
NOTE: ADJUST THE TENSION OF THE ROTO-LOCK CLAMPS SO
THAT THE SPEAKER FRAME IS FLAT. THIS WILL HELP ENSURE THAT
THE GRILLE CONTACTS THE CEILING ALL THE WAY AROUND THE
SPEAKER FOR A PROPER FIT.
6.Themicro-trim grilleisheldinplace byseveralsmall,powerful
magnets on the speaker frame. Place the grille against the
speaker and the magnets will hold it firmly in place. When
properly installed, the grille trim should make contact with the
wallallthewayaroundthespeaker.
Before Installation
1.Determinethelocation forthespeaker (seeSpeaker Placement
on page 1).
2.Performanobstructionsurveyusingastudfindertobecertainthat
therearenostuds,conduit,pipes,heating,ducts,pocketdoorsor
airreturnsintheceilingcavitythatwillinterferewiththespeaker.
Ifyouareunsureaboutobstructions,drillasmallholeinthecenter
oftheoutlineandinsertacoathangerwireintotheholetofeel
around for possible obstructions.
3.Cutthemountingholeusingakeyholeordrywallsaw,andrun
the speaker wires from the mounting hole to the amplifier
location.
NOTE: CONSULT LOCAL BUILDING CODES BEFORE RUNNING
SPEAKER WIRES THROUGH CEILINGS.
Installation
Sonance Visual Performance Speakers feature integral
Roto-Lock® mounting system for quick mounting directly into
existing ceilings.
1.Strip1/4”–1/2”(6mm–12mm)ofinsulationfromeachspeaker
lead. Twist the strands or tin the exposed wire with solder to
ensurethattherearenostraystrands.
NOTE: STRAY STRANDS THAT TOUCH EACH OTHER CAN CAUSE
A SHORT-CIRCUIT THAT CAN DAMAGE THE AMPLIFIER.
2.The speaker’s terminals are spring-loaded. Push the top of
each terminal down to open the connector and insert the
exposedwiresintotheholesinthespringterminals.
Thespeaker’spositivespringterminalislabeledwithareddot;
thenegativespringterminalislabeledwithablackdot.Double-
check that you connected amplifier “+” to speaker “+” and
amplifier“–”tospeaker“–”.
VISUAL PERFORMANCE®ROUND SPEAKERS
2