SPALDING AA76100 User manual

107/17 ID# M760040
Toll-Free Customer Service Number for U.S: 1-800-558-5234, For Canada: 1-800-284-8339,
For Europe: 00 800 555 85234 (Sweden: 009 555 85234), For Australia: 1300 367 582
Internet Address: www.spalding.com www.spalding.com.au
REQUIRED
MATERIALS:
• Two(2)
Capable Adults
SAND
(60 lb.)
(27.2 kg)
• GardenHoseorSand
© COPYRIGHT 2017 by Russell Brands, LLC
• (2each)Wrenchesand/
orSocketWrenches
andSockets.
1/2”
1/2”
AND/OR
• LargeandSmall
AdjustableWrenches
OPTIONALTOOLS
AND MATERIALS:
Single Play
Netball System
Manual
This manual, accompanied by sales receipt, should be saved and kept on hand as a
convenient reference, as it contains important information about your model.
AdultAssemblyRequired.
• AllenWrench
1/8”
Position unit at least 6’ 7” (2 meters)
from buildings, water and electricity.
For family and domestic use only.
NOTE:
Write Model Number
From Box Here:
NOT SUITABLE
FOR CHILDREN
UNDER THREE
YEARS OF AGE
DUE TO SMALL
PARTS/CHOKING
HAZARD.
0-3
WARNING!
READ AND UNDERSTAND
OPERATOR’S MANUAL
BEFORE USING THIS UNIT.
FAILURE TO FOLLOW
OPERATINGINSTRUCTIONS
COULD RESULT IN INJURY
ORDAMAGETOPROPERTY.
WARNING!

2
21

3
IMPORTANT!
Remove all contents from boxes.
Be sure to check inside pole sections;
hardware and additional parts are packed inside.
NOTICETOASSEMBLERS
AdultAssemblyRequired.DisposeofALLpackagingmaterialspromptly.Aswithallchildren’sproducts,
periodicallyinspectforloosesmallparts.
AssembledunitMUSTbefilledwithwateratALLtimes.
ALL systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water
according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT
acceptable to devise a makeshift weight system.
SAFETY INSTRUCTIONS
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE AND WILL VOID WARRANTY.
Ownermustensurethatallplayersknowandfollowtheserulesforsafeoperationofthesystem.
To ensure safety, do not attempt to assemble this system without following the instructions carefully. Proper
and complete assembly, use, and supervision are essential for proper operation and to reduce the risk of
accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and
operated properly.
• Ifusingaladderduringassembly,useextremecaution.
• Checkbaseregularlyforleakage.Slowleakscouldcausethesystemtotipover
unexpectedly
• Seatthepolesectionsproperly(ifapplicable).Failuretodosocouldallowthepole
sections to separate during play and/or during transport of the system.
• Climate,corrosionormisusecouldresultinsystemfailure.
• Iftechnicalassistanceisrequired,contactCustomerService.
• Minimumoperationalheightis4’-6”(1.37m)tothebottomofbackboard.
Most injuries are caused by misuse and/or not following instructions.
Use caution when using this unit.

4
PARTSLIST
Item Qty. PartNo. Description
1 1 600069 Base
2 1 208717 Axle
3 2 266200 Wheel
4 2 901285 Strut
5 1 203617 Cap, Base
6 1 901286 Bottom Pole Section
7 1 901287 Lower Middle Pole Section
8 1 901288 Upper Middle Pole Section
9 1 901289 Top Pole Section
10 1 901290 Rim
11 1 204326 Net
12 4 203153 Bolt, Hex, 5/16”-18 X 0.75”
13 7 203099 Nut, Nylock, 5/16”-18
14 1 600321 Cap, Pole
15 1 203113 Bolt,Hex, 5/16”-18 X 2.5”
16 11 203218 Washer, Flat, 5/16
17 2 205528 Bolt, Flange, 5/16”-18 X 1.00”
18 3 208718 Set Screw
19 1 600319 Thumbscrew
20 1 600320 Pole sleeve
21 1 500053 Warning Label
* You may have extra parts with this model.
Hardware is divided by
where it will be used.
Hardware Bag # Where used
1 Base Assembly
2 Pole Assembly
3 Goal Assembly
NOTE:

5
PARTSIDENTIFIER-ActualSize
PARTSIDENTIFIER-NotActualSize
#5 (1)
#19 (1)
#15 (1)
#17 (2)
#18 (3)
#12 (4)
203153 hex head bolt 5/16 x 3/4
#13 (7)
203099Hex Locknut (Nylon Insert) 5/16-18
#16 (11)
#10 (1) #4 (2)
#2 (1)
#11 (1) #1 (1) #14 (1)
#3 (2)

6
Gettoknowthebasicpartsofyoursystem...
TOP POLE
MIDDLE POLE
(UPPER)
RIM
BOTTOM POLE
BASE
MIDDLE POLE
(LOWER)
STRUTS

7
1. Correctly identify each pole section. SEE BELOW
7
9
TOPMIDDLE
(LOWER)
BOTTOM MIDDLE
(UPPER)
8
6

8
2. Align bottom pole (6) with set screw hole towards rear of base. Then assemble bottom pole
(6) to base (1) by sliding axle (2) through base (1) and wheels (3) as shown.
IMPORTANT!
NOTE ORIENTATION.
6
23
3
1
SET SCREW HOLE
LOCATION FACES
TOWARD REAR OF
SYSTEM
NOTE:

9
3. Secure base struts (4) to bottom pole (6) using bolt (15) washer (16) and nut (13).
Rotate struts down and bend strut outward to line up with hole on base as shown. Secure
free end of base strut to base with bolt (17), washer (16), and nut (13) as shown. Repeat for
other side.
4.
6
1
4
16
4
13
6
17
17
1
4
4
16 13
16 13
15

10
5.
7
6
6
7
1
Insert lower middle pole (7) into bottom pole (6). Align slot and tab to orient the welded
nuts to face the rear of system and use set screw (18) to secure in place.
IMPORTANT!
NOTE ORIENTATION.
18

11
6.
818
9
Insert top pole (9) into upper middle pole (8). Align slot and tab to orient the welded nut
opposite of the top pole’s plate and use set screw (18) to secure in place.
Install pole cap (14) into top pole (9)
IMPORTANT!
NOTE ORIENTATION.
8
9
14

12
7.
8. Install net (11) on rim (10).
10
13
13
9
16
16
16
16
13
13
16
16
16
16
OUTSIDE VIEW
B.
D.
C.
A.
10
11
11
10
11
Install rim (10) onto top pole (9) using bolt (12),
washer (16) and nut (13) as shown below.
12
12 12
12

13
9.
7
8
19
7
8
Plastic sleeve
insert (20)
Slide the adjustable upper pole assembly (from steps 6-8) into lower middle pole (7).
Align holes to face toward rear of system and use thumbscrew (19) to secure in extended
position by aligning the dimple with thumbscrew (19). Use the set screw (18) to lock the
upper pole assembly in place.
IMPORTANT!
NOTE ORIENTATION.
9
6
18
Dimple

14
ID# M5800156 03/09
11. Place assembled unit in desired location.
Fill base completely with water (7.2 gallons /
27.25 liters) or sand (approx. 60 lb./27.2 kg)
and snap base cap (5) in place.
ADD ONE GALLON (3.78
LITERS) OF NON-TOXIC
ANTIFREEZE IN SUB-
FREEZING CLIMATES.
CAUTION!
IFUSINGSAND:
1 GALLON OF
ANTIFREEZE IS
NOT REQUIRED
NOTE:
SAND
(60 lb.)
(27.2 kg)
10.
10 feet
(305 cm)
Apply height adjustment label (21) to front
of pole as shown.
5
1
21