StudioDesk Keyboard stand User manual

The Desk You Deserve
ASSEMBLY MANUAL
Keyboard stand
Keyboard stand Extreme
NOTE: Please assemble on soft surface to
avoid scratches or damages to the lacquered
wood.
!
www.studiodesk.net

The Desk You Deserve
Thank you for making StudioDesk the desk of your choice!
Before starting on assembling your keyboard stand let’s get familiar with the parts you have received in your
package. Please match the corresponding numbers on this page with the drawings.
1. Main board
2. Strengthening board
3. Legs - left and right
Hardware
Wooden parts
Tools you will need (Not included)
Rubber hammer
Cross screw driver
4
Metal corner 6 pcs
LR
3
Dim 28x30x50mm
R
Wooden Dowels 8 pcs
5
M6 Screw 24 pcs
6
12

1
Step One
Insert dowels (5) into the holes
as shown on the illustration.
Use rubber hammer If needed.
8
10
5
Place Main board and strengthening board
carefully to the corresponding holes on right leg.
Take a special Attention to avoid scratching on
lacquered surface. Push the middle section down
until the dowels seat properly in their respective
holes. Use a rubber hammer, if needed.
2
Step Two
3
Step Three
Fix assembled parts together using
metal corners (4) and M6 screws (6)
as shown in the illustration.
Note! Turn the metal corner’s shorter
edge 28 mm downward.
5
5
www.studiodesk.net

4
Step Four
Step Five
6
Step Six
8
Turn keyboard stand to a standing position.
Adjust rollers on the legs evenly (+ - 5 mm)
with Cross screw driver in case of uneven floor.
6
4
Once dowels are in place and boards sit tight to the leg,
use metal corners (4) and M6 screws (6) to fix the
middle section to the leg.
Note! Turn the metal corner’s shorter edge
28 mm downward.
5
Carefully lift the left leg on top of the middle section
to match leg holes with the dowels. Ensure that every
dowel lines up with its corresponding hole on the leg.
Gently push the leg down until the middle section
seats together.