StudioDesk VTV01WH User manual

VTV01WH V tower speaker stand white
VTV01BL V tower speaker stand all black
Please assemble your product on soft
surface to avoid scratches and damages
on lacquer.
!
www.studiodesk.net

The Desk You Deserve
Thank you for making StudioDesk your desk of choice!
Before beginning assembly of your stand, let’s get familiar with the parts you have received in your package.
Please match the corresponding numbers on this page with the drawings.
1. Body
2. Base
. Top Shelf
Hardware
Wooden parts
Tools needed (Not included)
4
Glides
8 pcs
5
M6 x 50 Screw
16 pcs
2 3
1
Barrel Nut
16 pcs
M6 x 16 Screw
8 pcs
8
7
NOTE: Base and top shelf are identical elements.
6
Tools included

3 Step Three
Insert dowels (7) into body parts as
shown on the right.
4 Step Four
Place Top Shelf ( ) on the corresponding dowels (7)
and press it down until it comes to the place firmly.
2 Step Two
Place body parts to the
base on dowels (7)
www.studiodesk.net
1 Step One
Insert dowels (7) into the holes as
shown in the illustration. Use a
rubber hammer if needed.

7 Step Seven
Push Barell nut into the hole with the screw driver
so the thread can be seen from the top. To the same on
All 4 holes.
Repeat the same procedure on the bottom
base. Ilustration 1,2.
8 Step Eight
Fix top shelf ( ) and body part with M6 x 50
Screws (4).
NOTE: Maximum safe load per speaker stand is 5 kg.
5 Step Five
Insert Barell nut in the hole as shown on the ilustration. Line on
the nut has to be towards the top.
Step Six
6
9 Step Nine Install Glides to the base using M6 x 16
Screws.
1
2