IMPORTANT!!
SPRINGS PER MODEL
(includes 2 extra springs)
PARTS LIST ALL MODELS
4 - Legs
4 - Frame Bars
1 - Jumping Mat
1 - Safety Pad
1 - Safety Plaque w/ 2 Ties
1 - Instruction Manual
1 - Backyard Trampolining Book
1 - Warranty Card
14' Super Bounce - 100 Springs
16' Mega Bounce - 108 Springs
XL Big Air - 124 Springs
Set-up Instructions - PLEASE READ CAREFULLY BEFORE SET UP!
NOTE: Before you begin, remove the shrink wrap from the end of each “round” frame bar. There is
a small insert that is used to protect the bar during shipping. Remove this insert and discard.
1 2
Lay 4 frame bars in a complete circle on a
level surface with the spring slots facing up.
Place the 4 leg bars inside the circle with the
leg ends near the leg insert sleeves on the
frame bars. Note: Make sure there is one
frame bar joint centered to each leg.
Lift 1 frame bar and slide a leg end into the
leg insert sleeve on the frame bar. Repeat
step for all 4 legs. Join the frame bars
together to close the circle.
Place the trampoline jumping mat on the
ground, inside the frame. Take one spring
and hook any one triangle on the jumping
mat. Hook the opposite end of the spring
into the spring slot on the frame bar.
When pulling the spring, grab the spring at
the end going into the hole in the frame. As
shown above, avoid holding the spring in the
red area as this will damage the spring.
3
ROUND TRAMPOLINE
SET-UP INSTRUCTIONS
ROUND TRAMPOLINE
SET-UP INSTRUCTIONS
ROUND TRAMPOLINE
SET-UP INSTRUCTIONS
ROUND TRAMPOLINE
SET-UP INSTRUCTIONS
SupeFun_instructions_8.5x11_FINAL.pdf 1 9/4/15 5:57 PM
