Swiftech Inc., 1703 E. 28th St., Signal Hill, CA 90806 T. (562) 595-8009 F. (562) 595-8769
NO PARTS PS
1BEZEL, FRONT 1
2BEZEL, FRONT, SUB 1
3BUTTON, POWER 1
4BUTTON, RESET 1
5LENS 1
6COVER, 5.25 FDD 4
7COVER, 3.5 FDD 2
8SPRING 1
9PLATE, CAGE, 5.25 2
10 SPEAKER 1
11 BULKHEAD ASSY 1
12 SHIELD, I/O 1
13 CAGE, 3.5 ASSY 1
14 CARDGUIDE 1
15 POWER SUPPLY 1
16 BRACKET, P/S 1
17 COVER, TOP 1
18 CHASSIS, BOTTOM 1
NO PARTS PS
19 PANEL, FRONT 1
20 PANEL, REAR 1
21 SIDE, PANEL 2
22 CAGE, 5.25 1
23 FILLER TOP 3.5 1
24 BRACKET, HDD 1
25 SLIDE BRACKET P/S 1
26 BASE, M/B 1
27 CROSS BAR 1
28 BRACKET, LED ASSY 1
29 FAN 120MM 1
30 SNAP RIVET 8
31 SHIELD 1
32 THUMB SCREW 2
33 SCREW 1
34 RIVET, ALUMINUM 49
35 RIVET-SUS 8
36 SCREW 20
37 MEMORY BOARD CROSS
BAR 1
Components installation
1. Open the side-panel #21 by loosening thumb screws #32
2. Remove the main cross bar #27, and the memory board cross bar #37 (discard #37 bar if not needed)
3. Loosen screw #33, and remove the front bezel #1
4. Remove the top cover #17
You now have full access inside the case to proceed with the installation of your power-supply, motherboard,
hard drive (s) and various components.
Liquid cooling circuit notes
• The water-block is installed onto the back-panel for safe shipping. Unscrew the 4 springs assemblies,
and remove the four aluminum standoffs used to secure the block to the back-panel. You will need
these standoffs later, together with the spring and screw assemblies to install the water-block onto your
motherboard.
• During installation of your motherboard inside the case, it is good practice to strap the block out of the
way, using a rubber band for example.
• Your cooling circuit is already filled with liquid (75% pure water, 25% antifreeze). All you need to do is to
install the water-block to your CPU (follow separate instructions for AMDor INTELprocessors).
• Power to the pump: a spare power cord is provided to supply A/C power to the pump. It needs to be
connected to an A/C outlet.
