Swing-N-Slide JAMBOREE User manual

PB 8328
WS 8328
JAMBOREE
IMPORTANT!!
PLEASE READ BEFORE BEGINNING ASSEMBLY!!
Please make sure all lumber, hardware and accessory parts are accounted for.
If you are missing anything, please DO NOT RETURN to the store where purchased.
Please call our Customer Service Department at the number below.
ASSEMBLY INSTRUCTIONS
© Swing-N-Slide Printed in USA

DIMENSIONS
STRUCTURE.

TOOLS REQUIRED
DRILL HAMMER TAPE MEASURE
PHILLIPS BIT CARPENTER
SQUARE
INCLUDED HARDWARE
Small
Square Bit
PLIERS

7
HARDWARE
1
1
3
7
4 2 4
1
2
1
12
Small

SA6066 BOX 1 of 2
BOARD LIST

9
SA6065 BOX 2 of 2
BOARD LIST

COMPONENTS

STEP 1
PANEL A
PANEL B
PANEL C
Check to make sure
structure is square
Per Board
Per Board
Per Board
NOTE HOLES
Install 30mm Screws
With Heads Flushed To
Board To Avoid
Protrusions. Per Board
Flush
Flush

STEP 2
PANEL D
Check to make sure
structure is square
PANEL E
ALL BOARDS
FLUSH
FLUSH
Per Board
Per Board
Per Board
Per Board
Per Board
Install 30mm Screws
With Heads Flushed To
Board To Avoid
Protrusions.
FLUSH

STEP 3
FRAME A
Note: Tap each T-Nut into its pre-drilled hole until the metal tangs sink fully into the wood.
Flush
Flush
Flush
Flush
NOTE:
HOLE
ORIENTATION
PANEL C
NOTE HOLES
T-Nut
Small
T-Nut
Small
Check to make sure
structure is square
Flush
to the bottom

STEP 4
FLIP FRAME
OVER
FRAME A

STEP 5
Flush
Flush
per Board
This Side
per Board
This Side
Note: Tap each T-Nut into its pre-drilled hole until the metal tangs sink fully into the wood.
FRAME B
WINDOW PANE INSTALL
NOTE:
HOLE
ORIENTATION
NOTE HOLE
T-Nut
Small
T-Nut
Small
Check to make sure
structure is square

STEP 6
FLIP FRAME
OVER
FRAME B

STEP 7
FRAME A
3’’
From Outside
of Post
Flush
Flush
PANEL A
94-1/4’’
NOTE HOLE
Check to make sure
structure is square
Side View of Tower
3’’ From
outside of post
To end of horizontal
support.
PF 6338
Flush to
outside edge
of 3”x 3”
PANEL A
Flush to
outside edge
of 3”x 3” Flush

STEP 8
FRAME B
FRAME A
Flush
Flush
19-1/2’’
Side View of Tower
3’’ From
Outside of Post
to End of Horizontal
Support.

STEP 9
NOTE:
PRE-DRILL
HOLES GOING
INTO DECK
SUPPORTS
per side
11’’ 11’’
Top View of Tower
Back of Tower
per side
Flush
Flush
55-1/4’’