Symmons Dia SPB-3510-1.5 Manual

SPB-3510-1.5
Dia™Single Lever Bar Sink Faucet
Operation & Maintenance Manual
Model Number Specifications
SPB-3510-1.5 Dia Single Lever Bar Sink
Faucet
Dia single lever bar sink faucet includes ceramic
cartridge, braided hose connections, rigid/swivel spout
and 1.5 gpm (5.7 L/min) ow restrictor.
Modifications Compliance
-1.0 1.0 gpm (3.8 L/min) flow restrictor outlet
spray
-1.5 1.5 gpm (5.7 L/min) flow restrictor outlet
spray
Delete 2.2 gpm (8.3 L/min) flow restrictor
Suffix 1.5 outlet spray
-DP4 4" deck plate for single hole mount
faucets
-STN Satin nickel finish
Note: Append appropriate -sufx to model number.
-ASME A112.18.1/CSA B125.1
-NSF/ANSI 61.9, NSF/ANSI 372
For California Residents
WARNING: This product contains chemicals known to the
State of California to cause cancer, birth defects, or other
reproductive harm.
Limited Lifetime - to the original end purchaser in
consumer installations.
5 Years - for commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
c
BB A
A
C
C
GG JJ KK
F
FEE
H
H
I
I
D
D
Note: Dimensions are subject to change without notice.
Measurements
A 4”, 102 mm
B 1 5/8”, 41 mm
C 1”, 25 mm
D 3 7/8”, 98 mm
E 10 13/16”, 275 mm
F 11”, 279 mm
G
(Hole Size)
Min. 1 1/4”, 32 mm
Max. 1 3/8”, 35mm
H 6”, 152 mm
I 7”, 178 mm
JMin. 7/8”, 22 mm
Max. 2 3/8”, 60 mm
K 3/16”, 5 mm
Warranty
Dimensions

2
Parts Breakdown
Required for Installation
Phillips head screwdriver
Allen wrench (3/16”)
Teon Tape
A
D
E
F
G
H
B
C
I
Replacement Parts
Item Description Part Number
B 1.5 gpm aerator RK-015-1.5
C Cartridge BL-120
DHandle
Assembly RK-013*
I8" Deck Plate
(optional) RL-032*
Notes:
*1) Append -STN to part number for satin nickel nish.
2) Append -1.0 or delete -1.5 for aerator ow restrictor.

Symmons Industries, Inc. ■31 Brooks Drive ■Braintree, MA 02184 ■Phone: [phone] ■ Fax: [phone]
Copyright © 2015 Symmons Industries, Inc. ■www.symmons.com ■[email protected] ■ZV-3031 REV B ■ 120115
1) Insert faucet body (A) through deck
plate.
2) Slide rubber washer (E), metal
washer (F), and nut (G) on to
threaded studs. Hand tighten nut
(G) then tighten screws (H).
3) Install Teon tape to inlets of
shut-off valves. Attach supply
lines to shut-off valves and hand
tighten. Using a wrench, nish with
one-half turn. DO NOT overtighten.
Installation
A
1
2
3
E
H
F
G
11
2
Care and Cleaning
1) Clean nished trim area with a soft cloth using mild soap and water or a non-abrasive cleaner and then quickly rinse
with water.
Troubleshooting Chart
Problem Cause Solution
Finish is spotting. Elements in water supply may cause
water staining on nish.
Clean nished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then
quickly rinse with water.
Faucet is leaking from handle or
faucet body.
Remove cartridge and inspect for
foreign matter. Replace cartridge if
necessary.
Cartridge o-rings are worn or foreign
matter (dirt, chips) is lodged between
cartridge and o-rings.
Soak cartridge in white vinegar for
1 hour to breakdown hard water
deposits, then rinse with water.
Replace cartridge if necessary.
Hard water deposit inside of cartridge
is preventing accurate mix of hot and
cold water.
Faucet no longer maintains desired
temperature.