Technitrend TN-09E User manual

Service Questions: Contact Sunpentown at (800)-330-0388
Sales Inquiries: Contact Sylvane at [phone] or visit sylvane.com

Parts
1. Control Panel
2. Cooling Air Outlet
3. Handle
4. Castors
5. Air Filter
6. Air Inlet
7. Exhaust Air Outlet
8. Cord Hanger
9. Water Stopper (Rubber Plug Inside)
Accessories
10. Adaptor - for insertion over the hose and
1 Exhaust Hose
Diameter: 4.75”
Round Connector - to be used between
hose and window kit or between hose and
wall.
Cap for Round Connector
16.
4
Front Back
13.
2.
11.
Remote Control
Drain tube
17.
Carbon filter
15.
exhaust hose.
space.
14.
14
lastic Slider it-for filling the open window
- for filling the open window
p
into the back of the air conditioner.
k
lastic Slider it
pk
Dimension:7 x24.5 x0.75
Length: 14”-60”
”””
Dimension:7 x24.5 x0.75
”””
space and with a hole for connection to
th

5
Mounting the unit
This unit is a portable air conditioner. It can be moved from room to room so that the cooling
can follow you anywhere. Fitting the exhaust hose is easy, through a window or wall.
Please refer to either of the following ways:
Installation
2. Using the Through the Wall
• Make a hole (5" in diameter) in the wall to fit the supplied round connector.
• Fit the hose directly to the round connector.
• When the hole is not in use, use the cap for the round connector to cover the hole.
FIG.5
FIG.6
FIG.7
Wall or Window
Outward adaptor
1. Using the
lastic sli er it
Pd k
Remove the 4 scre ws around the circular opening on the plastic kit.
Insert the round connector through the circular opening, the lip of the round connector
should be on the flat side of the slider kit. Align the screw openings and replace the 4
sc rews.
Determine how many se ctions of the slider kit your window/sliding door requires.
out.
To adjust the height of the slider kit: align the small openings on the side, when the
desired height is rea ched, insert a small scre w (not supplied)through one of the opening.
Extend one e nd of the exhaust hose a nd insert it into the Round Connector. Tighten hose
by turning clockwise.
Attach the Adapter to the other end of the hose. Tighten by turningAdapterclockwise.
Attach the Adapter to the back of the unit.
Slide window / patio door close a gainst the slider kit.
Make sure the exhau st hose ha s no kinks or sharp bends.
The be st distance betwee n the machine and window or wall is 31-39 inche s.
Place the sli der kit inside the window/door frame, with flat side of round connector
facing

Service Questions: Contact Sunpentown at (800)-330-0388
Sales Inquiries: Contact Sylvane at [phone] or visit sylvane.com