Tonka Dig n Go Construction none User manual

-SAND SIFTER BRIDGE --
- I
1. Fit sad -%WiNh
U~?X~~'~IPE 1 I
2. Fit rain pipe into position shdin. Usiig
Phitjcey riyer, (pure inplace witti$vd
- .~fiPiA. I ri 7
. n, -hWv i8;1-4 J :r. .? ;j4 *r I 1741 :.( ,, e ,
It . - 1 'I
1 I 1
I\ l
a* AXLE/WH~~~~~'&@ ti&
. 5. Pushwhe?mqt#,#h&I pithrim MI( out as
' ""sf%~.*h at w o n wheat
STl)i?A66 PANEL
3. Fi fo . o ,s)Dq( pneiInto posit~&hsnlokn. Uslng
fiG @r,wup 81 re np with
ivw viics'as (ihj NIP : Hinge sCre+@in~ 1s tbsignr! open
and clow'tb
stbm sand dnd atcbssbties. t shovel
atm hrisAele ss shown-wet).
, .
I
lY con.
the alFichedwshnut)
heel insert and through
axle sleeve.

AXLEIWHEEL ASSEMBLY CONT.
7. Push axle lhrough axle hole and
continue pushing all the way through the oppo.
site end.
GRIPPER CLAWlLlFT
10. Guide the upper gripper claw piece through the
lower gripper claw piece and snap slots onto
the lower gripper claw bar. Snap the lower lift's
slots onlo the upper lift's bar as shown.
AXLEIWHEEL ASSEMBLY CONT.
0. Slide the other axle sleeve over end 01axle then slide
the olher wheel (with wheel Insert) over end olaxle
as shown. Hold product on its side and secure wheel
in place with push nut as instrucled in Step
14.
rat rcc.m:at #a:ir~ tk sp~sb ~htti 07 I M::L ti md o
,In7 plNm nd3:r kbs hmsr~l
SHOVEL ARM SCOOP
A
SHOVEL ARM
11. The handles ol the gripper claw, lift and
shovel arm scoop all fit inlo the hole at end ol
shovel arm. Make sure the rounded areas oleach
piece match the rounded area of shovel arm
GUARORAILSIRETAINERWALLS
9. The lour guardrails and two retainer walls can
be inserted and removed from holes as shown.
.. '
STORAGE & PORTABILITY
12. Fil lhe dump truck, guardrails. relainer walls.
dinosaur "fossil" and constructlon cones under the
storage panel and close panel. (Sand can also be
stored here.)
betore inserl.rg To remove ezch pme,press
re ease bunon and p. p ece out. Each p ece can
also be uscd as a hand-held accessory!
STORAGE & PORTABILITY CONT. STORAGE
& PORTABILITY CONT.
13. \'11!h the shovel arm scoop inserted into lhe
14. Fit the end of shovel arm inlo drain plpe as shown (FIG I). then guide the shovel arm below storage pan.,
shovel arm. lit the handles of the gripper claw until it's secured in place (FIG
2). The sand hopper fils under shovel arm. Now you're ready to roll!
and lilt into holes in shovel arm as shown.
Prmwl ard LCI~~S mdy vary
' 1536 Haibro. Inc . Pawluckrt. Rhmr 11'1.10 02362 ill Ryhli Rercvzj
MADE IN USA. DUMP TRUCK WE IN CHINA.
92?<5 P:N4621203