TrailMaster cheetah i6 User manual

1
WNER’S/OPERATOR’S

2
The manual describes the safety and maintenance information of
the product. Please read the relevant warnings carefully before
using this product, or it may cause injury or death.
Please keep this manual in safe place. Any rider should read it.
When the product is transferred, the manual should be handed over
to new owner.
All the information, images and descriptions in this manual are
made according to the latest product. There are probably some
differences in the manual due to product improvement or changes of
production method. We reserves the right at any time to make
changes to the product without notice and no obligation to make
same or similar changes for the products manufactured or sold
before.
This product can not run on public or main roads, because this is
dangerous and violates local traffic regulations. Be sure to wear a
helmet, goggle and protective clothing while riding.
August, 2022

3
Main technical parameters
I. Main Technical Parameters of kart
1. Net weight（No battery）: 100kg;
2. Gross weight: 120kg;
3. Carrying capacity: 60kg;
4. Maximum designed carrying capacity: 65kg;
5. Maximum designed total weight:200kg;
II. The Main Parameters of Motor:
1. Motor type: DC, brush motor
2. Rated continuous output power: P=650W（2800±7.5%rpm）
3. Rated speed: 2800±7.5%rpm
4. Rated voltage: 48V
5. Max output torque: 15N.m@2500rpm.
III. The Main Parameters of Controller
1. Input rated voltage: 48V
2. Input voltage range: 48V
3. No-load input current: ≤115MA
4. Maximum output current of Motor: 42±0.5A
5. Under-voltage protection value: 42±0.5V
6. Maximum conduction value: ≥95% (Provided that controller output
current is less than 2A)
7. Starting voltage of foot rest: ≥1.4V
8. Protection voltage of foot rest: ≤1.8V
IV. The Main Parameters of Charger
1. Input: 100-240 VAC, frequency 50/60 Hz, input current 1.8A Max.
2. Output: 48V DC 1.5A
V. The Main Parameters of Battery
1. Size: 181*77*170mm
2. Model plumbic acid power battery 12V20AH 4 batteries

4
Name of each part
1 ANTI-ROLL BAR 8 FRONT
LOWER SUSPENSION
ARM ,L
2 SEAT 9 PROTECTING BAR
3 STERING WHEEL 10 FRONT
LOWER SUSPENSION
ARM ,R
4 UPPER SUSPENSION ARM 11 CUSHION ASS'Y. FR
5 STEERING GEAR ASSY 12 FR.WHEEL ASSY.R
6 SPINDLE AND STRUT SUPPORT,L 13 SPINDLE AND STRUT SUPPORT,R
7 FR.WHEEL ASSY.L

5
14
REAR CAGE RACK
21
Chain
15
VIN.NO
22
Brake
16
REAR WHEEL ASS Y.L
23
REAR SWING
17
Electric box
24
REAR WHEEL ASS Y.R
18
MOTOR
25
CUSHION ASSY. RR
19
Motor mount bracket
26
FRAME
20
Chain regulator
27
Controller

6
28
Battery case
30
Air break switch
29
Charger port

7
31
Brake pedal
34
3-speed switch
32
Accelerator pedal
35
Headlamp switch
33
Forward/Reverse Switch
36
Electric door lock(Switch
on/off)

8
Introduction
As a recreational vehicle, electric kart is only for non-road and single ride.
This mini electric bicycle is suitable for the young inexperienced riders with
weight less than 132 pounds.
Please understand the principles of electric kart before use. In order to protect
your kart, we suggest you to maintain it well. In addition to regular
maintenance, it’s also very important to comply and enforce the notes and
regular check summarized in this manual. You also can obtain useful safety
information, instructions and tips in this manual. Take good care of the manual
for reference if there’s any problem in future.
When reading the manual, you will notice the information marked "Caution".
This indicates this is critical information to help you avoid damage to the kart.
This manual also includes basic maintenance procedures. Please carefully
read the warranty content and understand the rights and obligations of
individual.
Whenever you use this product, please use reasonably as instructions and
gently stepping on pedals. Protect environment, keep cleanness and
openness of non-road area for convenient use in future.
Important safety information
Your personal or potential safety in using this vehicle is our greatest concern.
Safe operation is the most responsibility and can not be ignored.
Manual describes the safe operation procedures and warning signs in detail.
The information in this manual warns you potential danger may harm yourself
and others.
Certainly, this manual is not possible to clarify all the potential hazards
associated with non-road riding and maintenance. You should always keep
the best judgment.

9
There are various forms for safety information, including:
Safety labels on electric kart.
Safety sign and one of three signal words below: Danger, Warning and
Caution.
If above instructions can not be read and complied carefully, you or others
would be possible to be killed or seriously injured.
The manual contains important safety information. Please read it carefully and
understand it.
Safety first. Any electric product has inherent risks, there’s no exception for
electric kart. Carefully read the following warnings to avoid hurting yourself,
others and the electric Kart.
Rule 1
User Guide contains valuable and important safety information to ensure your
personal safety and avoid your bike damaged due to negligence. Please read
carefully and understand the relevant content. If you have any question
Rule 2
Adult supervision
Electric products are not toys. Children are forbidden to use this product alone.
Children under age of 8 are not allowed to use. All children have to be
accompanied by parents. 8-year-old age is just an estimated limit. Riding is
also affected by weight, height, driving ability and other factors. Parents
should make decision if your child can ride or not after considering
comprehensively his / her driving level.
危险

10
Rule 3
At one’s own risk and common sense
When using electric products, any accident is likely to cause serious injury
even death. Avoid riding in front or back out of sight, not drive where there are
other vehicles, avoid riding too fast. Speed should be kept in permitted range.
Always comply with local traffic laws and regulations, prohibit riding within the
banned range.
Rule 4
Riding on public roads is prohibited.
The bike is only used for non-highway. Riding on public roads or near motor
vehicles is prohibited.
Rule 5
RIDE SMART
Two or more people riding one bike is prohibited. Always keep your hands on
handlebars. Wearing headphones or using cell phone in riding is forbidden.
Fingers and other parts of body should be away from the moving parts, such
as drive chain and sprocket, which may cause injury. It’s not allowed to jump
off the bike on slope or near stairs, ride near pond or fountain. Related riding
clothes should be kept wearing, including gloves, knee pads, antiskid shoes,
helmet and goggles specified by DOT. Keep clothes and shoelaces away from
the moving parts of bike, like drive chain and sprocket.
Personal injury or death would be caused if above rules and warnings are not
complied with. Use cautiously and pay attention to surrounding environment,
practice techniques of safe riding.
If you have agreed your child to ride this bike, please keep following in
mind:
• Helmet has to be worn by child.
• Child’s safety is your responsibility and can not be ignored.

11
• Do not let your child try to ride if he/she is not ready for it.
• You have to accompany your child when he/she is riding.
• Proper repair and maintenance are the key factors of safety ride.
Caution:
Bike performance would be affected if components which are not produced by
us are adapted or added on the bike. It is strongly recommended not to
remove original equipment or change the design and / or operation of vehicle.
Initial settings
This kart is shipped with the roll bar unattached. To attach the roll bar follow
these steps:
1、Attach the Left /Right side guards with
M8X50 bolts , R Washer and M8 Lock Nuts .
2、Attach the roof guards with M8X50 bolts , R
Washer and M8Lock Nuts .
3、Tighten all these bolts until the brush guard is
completely assembled. Torque should be in 22-
29N.m
The anti-roll bar has to be
installed, which will affect the safety of rider.

12
Charging the Battery
Your electric kart may not have a fully charged battery. Please charge the
battery before using.
When vehicle is not in regular use, recharge battery at least once a month
until normal use is resumed. If you have left the power switch on or your
product has not been charged for a long period of time the battery may reach
a stage at which it will no longer hold a charge.
The battery can be charged whether it’s on the kart or took off. Please follow
the outlined procedures for charging the battery.
1. Connect the charger to the battery.
2. Connect the charger to an electrical outlet.
3. Charge until the red ‘Charging’ light turns green.
4. When the ‘Charging’ light turns green, detach the charger from the outlet.
5. Detach the charger from the Electric kart.
6. Put the charger in safe place.

13
Operation controls
Operate accelerator, brake and other controlling parts of this electric kart
without looking. Please learn carefully the following diagram and be familiar
with the functions and position of each control part.
1 ANTI-ROLL BAR 8 FRONT
LOWER SUSPENSION
ARM ,L
2 SEAT 9 PROTECTING BAR
3 STERING WHEEL 10 FRONT LOWER SUSPENS
ION
ARM ,R
4 UPPER SUSPENSION ARM 11 CUSHION ASS'Y. FR
5 STEERING GEAR ASSY 12 FR.WHEEL ASSY.R
6 SPINDLE AND STRUT SUPPORT,L 13 SPINDLE AND STRUT SUPPORT,R
7 FR.WHEEL ASSY.L

14
14
REAR CAGE RACK
21
Chain
15
VIN.NO
22
Brake
16
REAR WHEEL ASS Y.L
23
REAR SWING
17
Electric box
24
REAR WHEEL ASS Y.R
18
MOTOR
25
CUSHION ASSY. RR
19
Motor mount bracket
26
FRAME
20
Chain regulator
27
Controller

15
28
Battery case
30
Air break switch
29
Charger port

16
31
Brake pedal
34
3-speed switch
32
Accelerator pedal
35
Headlamp switch
33
Forward/Reverse Switch
36
Electric door lock(Switch
on/off)

17
On/Off Switch:1
Throttle works while the button in at position of ON,
and it does not work while the button is at position
of OFF. Switch should be kept off to protect the
battery if no use for the vehicle.
Throttle:4
It controls the speed of the motor and is located in
the front right corner of the cockpit. To increase the
motor speed, push the throttle pedal downward. To
decrease the speed, let up on the pedal and it will
automatically return to the upright position and the
motor will stop running.
Throttle should be turned slowly to
avoid sudden speed
up when you rotate throttle
pedal.
Disk Brake:5
Disc brake is at rear wheel. The brake pedal is
operated manually, in the front left corner of the
cockpit. Carefully press the pedal with increasing
force until vehicle stops.
If brake too fast, the vehicle will slip
and be out of control.
3-speed Limit Key:2
Parents can use it to set the max spe
ed of this
vehicle. 3 numbers stand for the different max
speed as follows,
1. Lowest speed around 11KM/h.
2. Middle speed around 22KM/h.
3: Top speed around 35KM/h.

18
Forward/Reverse Switch
R: Reverse
F: Forward
Turn the switch only when the
vehicle stops completely. Otherwise the spare
parts like controller and motor may be broken.
Battery Indicator
Battery indicator shows the battery level.
The battery should be fully charged
after every use.

19
Before Riding
Please make sure that both you and kart are ready before riding.
The
following is checklist before ride. Every time before ride, be sure
to check the
following items.
Checklist before ride
1. Have you read and fully understood all content of manual?
2. Have you noticed and understood the security information about t
he
kart?
3. Do you know the location of operating components and how the
kart
is operated by these components?
4. Are you healthy both physically and mentally?
1. Do you drink and take drugs?
2. Do you wear the helmet?
3. Do you wear goggles?
4. Do you wear antiskid shoes and protective clothes?
Other suggestions about protective clothes
1. Gloves can protect your hands.
2. Antiskid shoes can protect your ankles.
3. Wear pants with pads for knee and waist.
4. Wear sport shirts with elbow pads for knee and waist.
Children are not allowed to ride withou
t helmet, which can
sign
ificantly reduce the probability and severity of head injuries. Motorcycle
helmet is one of the most important parts i
n security measures. Choose a
suitable and comfortable one and wear it.

20
Checklist before ride
1. Check tire pressure with tire gauge in toolbox, ensuring tire pressure
at 15-20 psi.
2. Check whether the rim is bent or damaged.
3. Check the battery power.
4. Check whether the drive chain needs lubrication or fixed.
5. Check whether brake parts can work normally.
6. Check if all screws, nuts and other parts are loose.
7. Check if accelerator can be rotated freely a
nd automatically
positioned after release
8. Ensure steering wheel is flexible turned.
Crash accidents or even serious injury or death can be caused if
improper maintenance is made. Be sure to check the kart before t ride,
ensuring kart is in good condition to make full use of electric kart.
Basic operation
The power of electric kart is 650 watts with voltage 48V. The power can not be
underestimated to prevent harm.
Step One: Turn on the power
The kart is equipped with power lock switch, which is convenient to operate
for owners. The switch can cut off all power. Turn on the switch, the power will
be connected.
In case of nobody on the kart, do not rotate the accelerator. Or
the kart will initiatively move forward which may cause great danger.
Turn off the switch, the kart will slowly stop. It should be noted that the key
should be removed from kart after turning off the switch.