Transforming Technologies Ohm Metrics CM410 User manual

Continuous Workstation Monitors
Model CM410
Instruction Manual
Ohm Metrics™
T r a n s f o r m i n g T e c h n o l o g i e s , L L C
O u t s t a n d i n g A l t e r n a t i v e s i n S t a t i c C o n t r o l

CM410 Installation Diagrams
1) Mount monitor under bench area (use included screws or
Velcro).
2) Attach the “Bench” cord (smaller plug) to the back of monitor
and attach the banana plug into the common point ground.
3) Plug AC power supply to monitor and grounded 110v outlet
(monitor grounded through AC Adapter). Bench light should
be green.
4) Operator LED should be RED and alarm will sound 1 long
beep.
5) With wrist strap worn correctly while plugged into monitor,
LED will go from RED to GREEN when in use indicating
grounding is functioning.
CM410 With
Mounting Bracket Wrist Strap
Power
Work Station Mat
Common Point
Ground

Operation
Monitoring begins when the coiled cord of the wrist strap is
plugged into the monitor or remote jack. The status of a wrist
strap resistance is indicated by a the bicolor LED and audi-
ble Alarm:
Stand-by indication.
If the wrist strap is removed or not being worn but is still
plugged into monitor, an audible alarm will sound for 4-6
seconds, and the “OP” (operator) led will be will be blink
RED.
Normal indication.
For normal operating resistance “OPER”/”BENCH” led will
be GREEN.
High alarm.
If the operator wrist strap or worksurface mat’s resistance is
higher than maximum, the corresponding led will turn RED
and audible alarm will sound.
Calibration and Verification
The CM410 is factory calibrated and fixed. It does not re-
quire re-calibration. It is recommended to verify proper op-
eration with the CM410PV verification unit available from
Transforming Technologies.

Service and Warranty
Transforming Technologies, LLC provides a limited warranty for the
Model CM400, CM410 and CM420. All new products are guaranteed to be
free from defects in material and workmanship for a period of one (1) year
from the date of shipment. Liability is limited to servicing (after evaluating,
repairing or replacing) any product returned to Transforming Technologies.
The company does not warrant damage due to misuse, neglect, alteration
or accident. In no event shall Transforming Technologies be liable for collat-
eral or consequential damages. To receive service under warranty, please
contact Transforming Technologies.
Wrist strap open circuit voltage
Alarm indicators
Alarm set point
Unit monitoring capabilities
Periodic Verification Units
Dimensions/Weight
Mounting
Power Supply
Audible Alarm
Adjustment
0.7 VDC, +0.1VDC @ < 2mA
Visual, audible
38 to 87pF (human body);
with1 meg ohm wrist strap resistance
One person and one mat
CM410PV: NIST Calibrated Periodic
verification tool for CM410
1.00” H x 2.40” W x 2.40” D
(2.54 x 6.10 x 5.84 cm)
7.80 oz
Mounting materials included
Input: 120VAC—60hz, Output: 12VDC, 200mA
10 beeps (max); 5 seconds
No adjustments required
3719 King Rd | Toledo, OH 43617 | P: 419-841-9552 | F: 419-841-3241 | [e-mail]
Product Specifications