TSS 2.5 x 2.5 Power Rack with In-Line Weight... User manual

2.5 x 2.5 Power Rack with In-Line Weight
Storage

Read all safety warnings, instructions and
illustrations provided for this piece of strength
equipment. Failure to follow all instructions listed
below may result in serious injury or death. User assumes all potential
risks of assembly or use of this product.
PERSONAL SAFETY
●Stay alert, watch what you are doing when assembling and operating the
strength equipment. Do not use the strength equipment while you are
tired or under the influence of drugs, alcohol or medication. A moment
of inattention while operating or assembling the strength equipment may
result in serious or fatal injury.
EQUIPMENT USE AND CARE
●Visually inspect all components in order to identify potential
deformation or damage. If damages are observed, discontinue assembly
and contact the manufacturer at [email protected],
[email protected].
●Multiple components involved with assembly of this piece of strength
equipment are above 50lbs and it is recommended that you have an
additional person to assist in the positioning of these items.
●Ensure that all components are securely fastened before use.
1

Required Tools
●Crescent Wrench
●9/16” Socket and Wrench
Parts
2.5PRWS-001 |(x1) |Part A
OR
*2.5PR-100 |(x1) |Part MB*
(Upgrade; Replaces Part A)
2.5PRWS-002 |(x1) |Part B
2.5PRWS-003 |(x2) |Part C
2.5PRWS-004 |(x1) |Part D
2.5PRWS-005 |(x2) |Part E
3PRWS-006 |(x2) |Part F
2

2.5PRWS-007 |(x2) |Part G
2.5PRWS-008 |(x10) |Part J
2.5PRWS-009 |(x2) |Part H
⅜” Flat Washer |(x28) |Part K
⅜” Lock Nut |(x32) |Part L
⅜” x 4” Bolt |(x32) |Part I
3

Assembly
In the Image 1 above the arrows
display where the bottom and top
crossbeam will be attached with
parts L and I. The organization of
the hardware for these locations
can be seen in Image 2.
Part B will have part H placed
with it in the organization
displayed above in Image 2 and
part D will have part H placed
with it in the same organization
as part B.
4

In Image 3 above displays where
all other hardware will be placed
and the organization of the
hardware can be seen in Image 4.
5

Image 5 above displays the organization of the remaining hardware
which will be used for part J.
6

*Place parts E, F, and G in desired location*
7

You have now completed assembling your very own 2.5 x 2.5 Rack with
In-line weight storage! Thank you for choosing Texas Strength Systems
for your fitness needs. If you have any questions, comments, or concerns
please don’t hesitate to contact our staff.
Contact Information
Email: [email protected]
Phone: [phone]
8