Unitek S1229C User manual
USB Type-C M.2 /SATA Enclosure
Thank you for choosing Unitek USB Type-C M.2 /SATA Enclosure .
Please read the user manual carefully before use and save them. If
you need any help, please contact our professional customer
service team at: support_us@unitek-products.com
Product Overview
User Manual
1
A-Type-C Female Port
B-Type-C Power Supply Port
C-On/Off Button
D-LED Status Light
Product Features
1. plug-and-play, no driver required
2. tool-free extraction design of SATA interface, easy to
disassemble and install;
3. USB 3.2 10Gbps transfer rate, giving full play to transmission
performance;
4.Type C interface, easy to use for connection, no need to
distinguish between the front and back;
5. support PCIE Gen 3x2 NVME 1.3 M.2 SSD;
6. support multi-size M.2 SSD specifications compatible
(2242mm/2260mm/2280mm).
7. support for SSD TRIM command and UASP acceleration;
8. support for PCIe3.1a M.2 interface and SATA3.1 interface
protocols respectively, displaying dual disk characters at the same
time; support for dual disk simultaneous reading, more new and
old storage devices are also easily transferred;
9. support native command queue (NCQ)
10. Compliant with SATA specification (revision 3.1)
LED light Signal
1. power light, green, always on when powered on.
2. SATA/M.2 disk position light, yellow, corresponding to the hard
disk device is inserted when the light, read and write flashing. 30
minutes no read and write hibernation state, hibernation disk
position light off state.
2
Note
1. The M.2 SSD port of this product adopts the M Key interface,
which belongs to PCIe & NVMe protocol channel, please check the
interface and protocol channel of the hard disk when installing M.2
SSD for this product;
2. Although the USB side of the product supports hot-swapping,
when installing M.2 and SATA disks, it must be done under a power
failure;
3. When disassembling and installing the hard disk cage, please
keep all accessories properly to prevent loss;
4. After use, if you need to remove the SSD/HDD disk or replace the
uplink PC side device for use again, it is recommended that the user
safely eject the device by using the button on the bottom right
corner of the system to safely remove the USB peripheral icon, then
turn off the power and remove the device or reconnect it to a new
uplink PC side device for use.
Package Contents
1x M.2/SATA Enclosure
1x USB A&C Cable
1x Mini Screwdriver
2x Screws
2x Sponge protection block
2x Silicone sticker
3
Note: the power switch key, the default power is on, long press for
3 seconds to turn off the power function in the case of power
Warrant
The Unitek External Compact Disk Drive covered by Unitek warranty
for 24 months. If the product fails due to manufacturer defects,
4
Table of contents
