Vax VRS24B User manual

Bagless Uprig t
Powermax
VRS24B / VRS25R
User Guide
vax.co.uk
Get Cleaning...
What’s your serial number? (Located on the base of the machine)
Note these down in case you need them in future. Please keep instructions for further use.
– – – – –

-
Unit
2
3
1
14
45
6
7
8
10
11
15
16
13
17
2
Mac ine Overview
1 Handle
2 Dirt container lid
3HEPA filter
4 Dirt container
5 Lower hose inspection tube
6On/off switch
7 Brushbar height ad uster
8 Vacuum head
9 Wheel
10 Cord clip
11 Dirt container release button
12 Crevice tool (stored in extension tube)
13 Extension tube
14 Hose clip
15 Hose
16 Power cord
17 Hose connector
18 Lower cord wrap with quick release
19 Unit recline pedal
20 Two (2) short screws
21 Two (2) long screws
22 TurboTool (Some models only)
9
12
19
18
20
21
22
WARNING: This cleaner has a constantly rotating brushbar which,
when left in contact with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE: Vax recommends that you raise the height of the brushbar
when using this cleaner on lino and hard flooring. Vax cannot be held
responsible for damage to these surfaces if the customer fails to take
notice of this recommendation.
PLEASE NOTE: Some parts may vary
according to model. Please check inside
flap of the box for more details.

vax.co.uk 3
General Safety Information
FOR HOUSEHOLD USE ONLY.
When using the vacuum cleaner, basic safety precautions should always
be observed, including the following:
1. Only use the vacuum cleaner indoors on dry surfaces. Do not
handle the plug or vacuum cleaner with wet hands. Do not use
outdoors or on wet surfaces.
2. Turn off the vacuum cleaner controls before disconnecting
or connecting from the electrical socket.
3. Always unplug the vacuum cleaner before connecting
or disconnecting the hose and accessories.
4. Children should be supervised to ensure that they do not play with
the appliance.
5. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
6. Only use as described in this manual. Only use Vax
recommended attachments.
7. Do not use the vacuum cleaner if it has been dropped,
damaged, left outdoors or dropped into water. Do not use the
vacuum cleaner with a damaged cord or plug. If the supply
cord is damaged, it must be replaced by the manufacturer or a
recommended Service Agent to avoid hazard and
invalidating the guarantee.
8. Do not pull or carry by cord. Do not use the cord as a handle,
close a door on the cord or pull cord around sharp edges or
corners. Do not run the vacuum cleaner over the cord. Keep
the cord away from heated surfaces.
9. Do not put any ob ects into openings. Do not use with any
openings blocked and do not restrict air flow. Keep all openings
free of dust, lint, hair or anything that might reduce airflow.
10. Keep hair, loose clothing, fingers and all parts of the body away
from openings and moving parts.
11. Do not pick up hot coals, cigarette butts, matches or any hot,
smoking or burning ob ects.
12. Do not pick up flammable or combustible materials (lighter fluid,
petrol, kerosene etc.) or use in the presence of explosive liquids
or vapours.
13. Do not vacuum up harmful or toxic materials (chlorine, bleach,
ammonia, drain cleaner etc.).
14. Do not vacuum up hard or sharp ob ects such as glass, nails,
screws, coins, etc.
15. Do not use without ALL of the filters in place.
16. Take extra care when vacuuming on stairs.
17. Keep vacuuming area well lit.
18. Store the vacuum cleaner in a cool, dry area.
19. Turn off the on/off switch before unplugging the
vacuum cleaner
20. Use only CE-approved 13 amp extension cords.
Non-approved cords may overheat. Care should be taken
to arrange the cord so that the cord cannot be tripped over.
WARNING: Always switch off and unplug the vacuum cleaner from
the electrical socket before assembling, opening or emptying the dirt
container, or before connecting/disconnecting the attachments.
CAUTION: The vacuum cleaner is a very powerful unit. Before
plugging the cord into the electrical socket, make sure the switch
is in the ‘off’ position.
IMPORTANT: If the inlet, hose or telescopic tube is blocked, switch off
the vacuum cleaner and remove the blockage(s) before re-starting the
vacuum cleaner. See Maintenance:
Clearing blockages.
IMPORTANT: Washing filters maintains vacuum performance. Vax
recommends that they should be checked and cleaned periodically
(depending on the level of use). Make sure all filters are completely
dry before inserting back into the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any
reason the unit should overheat, the thermostat will automatically turn
the unit off. Should this occur, unplug the vacuum cleaner from the
electrical socket and turn off the switch. Remove dirt container and
empty. Clean filters. Allow the unit to cool for approximately one (1)
hour. To re-start, plug into an electrical socket and switch back on.
T is vacuum cleaner is intended for ouse old use only and NOT
for commercial or industrial use.
PLEASE KEEP INSTRUCTIONS FOR FURTHER USE.

- Operation
4
IMPORTANT: Always remove the power plug from the electrical outlet before assembling or removing accessories.
Assembling your vacuum cleaner
Firmly push the back panel
onto the base assembly.
Ensure it is fully located
before inserting the two
short screws.
Slide the handle into
place onto the top of the
back panel.
Secure the top handle to
the back panel by inserting
the two long screws.
Line up here
Insert the bottom of the dirt
container to align with the tab
on the upper cover of the
motor. To secure the dirt
container, push the top in
place, there will be an audible
click when it is secure.
Align the tabs on the
lower hose/inspection
tube with the slots on the
hose.
Push and turn the hose
clockwise until secure.
Wrap the hose round and
through the hose clip and
then down and insert into
hose connector.
This vacuum cleaner is equipped with a convenient cord storage feature. The
power cord winds around the two cord holders at the side of the unit. The bottom
cord holder has a quick release feature. Turn the cord hook to the left or the right
to remove the power cord.

On/o
switch
Operation
vax.co.uk 5
Operating t e appliance
press
ere
Turn the vacuum cleaner
on by pressing the on/off
switch located on the
lower right side of the
cleaner. The cleaner can
be turned off by pressing
the on/off switch again.
To ad ust the angle of the
vacuum cleaner body,
push the recline pedal
on the lower left side of
the cleaner.
Move the handle to the
desired position. (A) for
upright position, (B) for
normal operation and (C)
to clean under furniture.
Secure the top handle to
the back panel by inserting
the two long screws.
A
B
C
The front of the vacuum cleaner has a brushbar height ad uster that raises and
lowers the brushbar to suit the type of carpet. With the cleaner NOT connected
to the electrical outlet, and when the vacuum is in the upright position set the
ad ustment to the lowest setting for maximum cleaning. If the cleaner is difficult
to move, push the knob to the next highest setting until the vacuum is comfortable
to push. The brushbar must reach the carpet for effective cleaning.
IMPORTANT: When the vacuum cleaner is stood in the upright position or when
using the hose and tools, the brushbar height ad uster must be set to the highest
position.
WARNING: To avoid in ury, keep loose clothing, hair, fingers and all other parts of
the body away from any moving part (such as the brushbar). Turn off the switch
and unplug the cleaner before ad usting the cleaner for the carpet height.
Using accessories
The accessories can be used with or without the extension tube. To attach,
remove the hose from the machine and push the desired accessory onto the end.
Crevice Tool
Use the crevice tool for radiators, crevices, corners, skirting boards and
between cushions.
TurboTool (Some models only)
For pet hair, stairs and upholstery. The TurboTool should be pulled backwards
for optimum cleaning.