Ventev ES1-IS-2450 User manual

ES1-IS-2450 Hazardous Environment Enclosure
Installation Instructions
www.ventev.com/infra [email protected] 800-851-4965
1) Install the tap-in mounting feet included with the enclosure. Mount the enclosure in the desired
location. Refer to Figure 1 for mounting dimensions.
Figure 1.
2) Install the QTY (4) Solexy RF Couplers to the enclosure, as well as a conduit coupler (not supplied) for AC
Line and Data entry per coupler and enclosure manufacturer documentation.
Figure 2.
Disclaimer
:
Explosion-proof enclosures should be installed, inspected, and maintained by qualified and competent personnel.
Review the Crouse Hinds ECP documentation for ECP ATEX/IEC Ex Explosionproof Enclosures
(http://www.cooperindustries.com/content/dam/public/crousehinds/resources/pdfs/instruction-sheets/if1665.pdf) and
Solexy RX series coupler documentation (https://products.solexy.net/public/UserFiles/File/pdfdownload/RX_IOM_ATEX-IECEx.pdf)
before and during field installation for detailed installation and maintenance procedures. To avoid risk of electrical shock, electrical
power must be off before and during installation and maintenance.

ES1-IS-2450 Hazardous Environment Enclosure
Installation Instructions
www.ventev.com/infra [email protected] 800-851-4965
3) Connect the RF jumpers from the radio ports to their corresponding couplers. Install the antennas as
shown in Figure 3. Plug in ethernet cord.
Figure 3.
4) Close the lid on the enclosure and tighten all cover screws to 40-45 foot-pounds (55-61 Newton-meters.
Figure 4.