Victory 4x4 VTDLM Configuration guide

3RD GEN TACOMA
DITCH LIGHT MOUNTS
Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-459-8447!
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.

INCLUDED HARDWARE
N/A

INCLUDED PARTS
2x

1. Start by opening up your hood and remove the (2) factory hood bolts on
either side of the vehicle using a 12mm socket. Be sure to support the
hood once the bolts are out as it will be free and want to fall. Be sure to do
one side at a time.
INSTALLATION
2. Once the bolts are removed, take the supplied bracket and line the bolt
holes on the hinge up with the vertical slot on the bracket and loosely
thread the factory bolts back into the hood to secure the bracket. You may
need to adjust the depth of where the bracket sits so it doesn’t hit the
windshield when you close the hood. You can carefully and slowly close
your hood to verify, once you have the distance set, fully tighten down the
bolts with a 12mm socket.

3. Once both brackets are installed and tight, you are now ready to add the
lights of your choosing and wire them how you please. There are small
holes cut out into the brackets to help route and clean up your wiring with
zip ties.
INSTALLATION