VonHaus 05/072 User manual

SLIM FULL MOTION
WALL MOUNT
05/072 - Instruction Manual

CONTENTS
Safety Instructions, Tools Required 1
Wood Stud Wall Mounting
Solid Wall and Brick Mounting
Attaching the Display to the VESA Plate
Using the Spacers
Warranty
Components, Removing the Decorative Cover
Attaching the Brackets
2
3
4
5
6
7
8

1
WARNING
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE
TOOLS REQUIRED (NOT INCLUDED)
Power Drill
Suitable Drill Bit
Cross-Head Screwdriver
Spirit Level
Pencil
Hammer
Stud Finder
SAFETY SYMBOLS
Please follow the following safety and guidence.
WARNING! Pay
attention to all
safety and
guidance
Read manual
before use
Wear a dust
mask
Wear eye and
ear protection
TOOLS REQUIRED
WARNING! Do not exceed the maximum stated load
capacity of 45kg/99lbs. Installing appliances heavier than
recommended may result in damage or serious injury.
For strength with certain weaker walls and materials, the
unit should only be affixed to wall studs. If uncertain,
contact a qualified contractor for guidance.
Use of a Stud Finder (not included) is recommended.
The supplied mounting hardware is suitable for mounting
on most types of wall. It should not be mounted on steel
stud or old cinder block walls.
If the hardware you require for your wall is not included
or you are uncertain about the material, quality or
suitability of your wall, please consult your local
hardware store for guidance.
Do not over-tighten the mounting screws.
CAUTION: To ensure continued safety, check the unit is
secure and safe to use at regular intervals (every 3
months). Take appropriate action to rectify any unstable
or unsafe units.
If you do not understand these directions, or have any
doubts regarding the safety of the installation, please
seek advice and guidance from a qualified contractor.
This unit is intended for indoor use only. Do not use this
unit for any purpose that is not explicitly specified in this
manual.
Install only as instructed within this manual. Any deviation
or shortcut may lead to improper installation, incorrect
assembly or be considered customer misuse.
Improper installation may cause damage or serious injury.
Appropriate safety gear must be worn and precautions
taken when installing this unit.
We recommend two people are present to install this TV
Bracket.
This unit is not a toy and is not suitable for children.
Children should be supervised at all times around this unit.
This unit contains small parts and components which pose
a choking hazard to children and animals. Keep these
parts clear from children and pets.
Check the contents of the packaging against this manual
to ensure there are no missing or defective parts. Never
use defective parts.
Ensure the supporting surface will safely support the
combined weight of the equipment and all hardware and
supporting components before installation. If unsure,
contact a qualified contractor for guidance.
2 person assembly is recommended.

COMPONENTS
Wall Mount (x1)
A
Arm (x2)
B
Wall Mount Template (x1)
C
Spanner (x1)
D
M5x14 (x14)
M-A
M6x14 (x4)
M-B
M8x20 (x4)
M-C
M6x30 (x4)
M-D
M8x30 (x4)
M-E
ST6.3x55 (x6)
W-A
Small Spacer (x8)
M-G
Large Spacer (x4)
M-H
Washer (x5)
W-C
Rectangle
Spacer (x4)
M-F
Concrete Wall
Anchor (x3)
W-B
REMOVING THE DECORATIVE
COVER
Gently pull the Decorative Cover (E) to remove and retain for future use.
Decorative Cover (x1)
E

WOOD STUD WALL MOUNTING
Drill pilot holes.
Use
outlet
as guide
Approx
16-24’’
apart
Stud
Locate an appropriate installation area.
NOTE: Use of a Stud Finder (not
included) is recommended.
1. Place the Wall Mount Template (C)
against the wall where it is to be
mounted (over a wall stud.) Mark the
centre point of the 4 centre mounting
holes. Drill pilot holes in these
positions.
2. Insert 4 W-A Wall Mounting Screws
with 3 W-C Washers (top Screw does
not require a Washer) and tighten,
leaving approximately 5mm of the
Screw exposed from the wall. When
mounting on a wall stud, W-B Concrete
Wall Anchors are not required.
3. Using two people, lower the Bracket
over and onto the Screws and fully
tighten to secure.
CAUTION: Ensure Screws are
tightened fully before allowing the
fixings to take the weight of the
Bracket.
For strength, it
is recommended
that you mount the
Bracket on a wall
stud.
W-A
W-A
W-C

SOLID WALL AND BRICK MOUNTING
Find and mark the exact location
of the mounting holes.
Drill pilot holes.
4
1. Locate a suitable place for installation.
CAUTION: Avoid anylive or utility wires which may be positioned behind the wall.
2. Place the Wall Mount Template (C) against the wall where it is to be mounted. Mark the centre point of the 2
furthest holes and the centre mounting hole on the top and bottom of the template. Drill pilot holes in these positions.
3. Insert 6 W-B Concrete Wall Anchors into the holes. Insert 6 W-A Wall Mounting Screws with 5 W-C Washers (top
centre Screw does not require a Washer) and tighten, leaving approximately 5mm of Screw exposed from the wall.
4. Using two people, lower the Bracket over and onto the Screws and fully tighten to secure.
CAUTION: Secure the Screws fully before allowing the fixings to take the weight of the Bracket.

ATTACHING THE ARM TO THE WALL
PLATE
ATTACHING THE ARMS
5
Re-attach the Decorative Covers (E).
Remove small screw to unlock the Arms (B) and retain for future use.

USING THE SPACERS
M-F
M-C
M-B
M-A
M-C
M-C
M-F
M-F M-F
M-H M-H
M-G M-G
M-G
M-D M-D M-D M-E M-E M-E
M-F
M-G
Attach the Arms (B) to the back of your television using the suitable Mounting Screw (M-A, M-B, M-C, M-D, M-E) and
M-F Rectangle Spacer.
NOTE: Some sets will require use of M-G or M-H Spacers as illustrated to ensure a flat fit against the back of your set.

ATTACHING THE BRACKETS
D
1. Using two people, lower the television onto the Bracket. Close over the bottom clamps on the Arms (B) to secure the
Bracket. Insert and re-tighten the Screws removed earlier to secure.
2. Secure all Bolts as illustrated with Spanner (D) to align the television into the desired viewing position.
3. Feed through wires (with sufficient length left over for movement) and press gently back into place to secure.
NOTE: Loosen (but do not remove), re-position, then re-tighten the Bolts for future adjustments.

DISPOSAL INFORMATION
COPYRIGHT
WARRANTY
Please recycle where facilities exist. Check with your local authority for recycling advice.
All material in this instruction manual are copyrighted
by DOMU Brands Ltd.
Any unauthorised use may violate worldwide
copyright, trademark, and other laws.
9
To register your product and find out if you qualify for a free extended warranty, go to:
www.VonHaus.com/warranty
Please retain a proof of purchase receipt or statement as proof of the purchase date.
The warranty only applies if the product is used solely in the manner indicated in the Warnings page of this
manual, and all other instructions have been followed accurately. Any abuse of the product or the manner in
which it is used will invalidate the warranty.
Returned goods will not be accepted unless re-packaged in its original box and accompanied by a relevant and
completed returns form. This does not affect your statutory rights.
No rights are given under this warranty to a person acquiring the unit second-hand or for commercial or
communal use.

Thank you for purchasing the Slim Full Motion Wall Mount.
VonHaus is a registered trademark of DOMU Brands Ltd
Made in China for DOMU Brands Ltd BL2 2HH