Wheelock EN4 User manual

P83937 E
Sheet 1 of 3
273 Branchport Avenue
Long Branch, NJ 07740
[phone]
www.wheelockinc.com Thank you for using our products.
INSTALLATION INSTRUCTIONS
INDOOR/OUTDOOR STROBE APPLIANCE ENCLOSURE
EN4
Use this product according to this instruction manual. Please keep this instruction manual for future reference.
GENERAL:
Indoor/Outdoor Strobe Appliance Enclosure, Model EN4, is designed to be used with Wheelock’s Series RSS Strobe Appliance. The
EN4 enclosure, rated as a NEMA 4 enclosure, provides protection from windblown dust, rain and snow. The EN4 enclosure is UL
Listed for use, both indoors or outdoors, in areas with a temperature range from 0˚C (32˚F) to 49˚C (120˚F). See Table 1 below for
UL listed candela (cd) ratings of the RSS Strobe when using the EN4 Enclosure.
NOTE: All CAUTIONS and WARNINGS are identified by the symbol . All warnings are printed in bold capital letters.
WARNING: PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THIS PRODUCT. FAILURE
TO COMPLY WITH ANY OF THE FOLLOWING INSTRUCTIONS, CAUTIONS AND WARNINGS COULD RESULT IN
IMPROPER APPLICATION, INSTALLATION AND/OR OPERATION OF THESE PRODUCTS IN AN EMERGENCY
SITUATION, WHICH COULD RESULT IN PROPERTY DAMAGE AND SERIOUS INJURY OR DEATH TO YOU
AND/OR OTHERS.
WARNING: DO NOT USE THE EN4 ENCLOSURE IN INSTALLATIONS WHERE TEMPERATURES MAY FALL
OUTSIDE OF THE UL LISTED TEMPERATURE RANGE TEMPERATURE [0˚C (32˚F) TO 49˚C (120˚F)] AS DAMAGE TO,
OR FAILURE OF, NOTIFICATION APPLIANCE MAY RESULT.
WARNING: DO NOT SET THE MULTI-CANDELA STROBE APPLIANCE ON THE 15cd SELECTION. THE
REDUCED LIGHT OUTPUT RATING FOR THE 15cd SELECTION WILL NOT MEET THE MINIMUM
REQUIREMENTS OF NFPA 72. USE SETTINGS OF 30cd OR HIGHER.
SPECIFICATIONS:
Table 1: UL Candela Ratings for Series RSS Strobe when using EN4 Enclosure.
Multi Candela Series
(Selectable)
Audible/Strobe
Combinations
(Non-Selectable)
Model No’s Candela
Setting Model No. *
Strobe
Candela
(cd)
Using EN4
RSS-2430W 21.0
RSS-2475W 52.5
RSS-24MCW 30cd, 75cd,
110cd RSS-24110W 77.0
RSS-2430C 21.0
RSS-2475C 52.5
RSS-24MCC 30cd,
75cd, 95cd RSS-24100C 70.0
Refer to Series RSS (P83500 and P83501), RSS Multi-Candela Wall (P83911) and RSS Multi-Candela Ceiling (P84394) Installation
Instructions for additional information.
Copyright 2003, 2004 Wheelock, Inc. All rights reserved.

P83937 E
Sheet 2 of 3
MOUNTING INFORMATION:
GASKET
CLEAR
P0LYCARBONATE
COVER
(4) #8-32 X 3/8" SOCKET
HEAD SCREWS
(4) RETAINING CLIPS
(4) #10 X 1-1/2"
(4) MOUNTING TABS
(4) 12 X 1"
INSERT THE (4) EXTERNAL MOUNTING
TABS INTO ENCLOSURE SLOTS AS
SHOWN. USING ENCLOSURE ASSEMBLY
AS TEMPLATE, PLACE AGAINST MOUNTING
SURFACE WITH CENTERLINE 80 INCHES
ABOVE FLOOR, MARK AND DRILL (4) HOLES
1/4" DIA. X 1" DEEP.
HORIZONTAL
CENTERLINE
OF ENCLOSURE
MOUNTING HEIGHT 80"
FRONT VIEW OF ENCLOSURE
CENTERLINE
NOTE: AFTER ALL INSTALLATION PROCEDURES HAVE BEEN COMPLETED, INSTALL GASKET IN ENCLOSURE GROOVE NOW
PLACE COVER IN GROOVE AND POSITION THE FOUR (4) CLIPS IN THE SLOT CLOSEST TO EDGE OF COVER.
4 IN SQUARE, FLUSH BACKBOX MOUNTING INSTRUCTIONS
GASKET
A
B
C
D
F
E
CENTERLINE
TOP VIEW
1-1/4"
CONDUIT ENTRY HOLE
MUST BE FIELD DRILLED.
1. DRILL A PILOT HOLE
(MAXIMUM 1/2")
2. COMPLETE DIA. USING
A 1-1/16" DRILL BIT
OR HOLE SAW.
1. Figure A is typical of a ¾ in. Rain tight conduit hub with neoprene o-ring threaded for rigid
conduit and imc. (O-Z/GEDNEY #CHM-75 or equivalent.)
2. Figure B is typical of a ¾ in. female adapter (Carlton #E942 or equivalent).
3. Figure C is typical of a ¾ in.-1/2 in. reduce bushing (Appleton #RB series or equivalent).
4. Figure D is typical of a galvanized ½ in. conduit nipple.
5. Figure E is typical of a ½ in. conduit lock nut.
6. Figure F is typical of a 4 in. X 2-⅛in. Deep Square Backbox 9RACO190 or equivalent).
STAND-OFF INSTALATION
INSTRUCTIONS FOR AREAS WITH
FREQUENT WASHDOWNS
STAND OFF BLOCKS (4)
EXTERNAL MOUNTING
TABS (4)
CLEANING INSTRUCTIONS FOR
ENCLOSURE AND COVER
1. Rinse with water to remove abrasive dust
and dirt.
2. Wash with soap or mild detergent, using a
soft cloth (do not scrub).
3. Rinse once more, than dry with a soft cloth
or chamois.
4. Rinse with water to remove abrasive dust
and dirt.
5. Wash with soap or mild detergent, using a
soft cloth (do not scrub).
6. Rinse once more, than dry with a soft cloth
or chamois.
To remove grease or wet paint, rub gently with a
cloth wetted thoroughly with naptha then wash
and rinse. DO NOT USE RAZOR BLADES.

P83937 E
Sheet 3 of 3
WARNING: FAILURE TO FOLLOW THE INSTALLATION INSTRUCTIONS OR TO SUBSTITUTE ELECTRICAL RIGID
CONDUIT FITTINGS THAT DO NO COMPLY WITH CURRENT PRACTICES ADAPTED BY NEC, NFPA AND ANSI CODES
MAY RESULT IN LOSS OF PROTECTION FROM WATER OR DUST.
WARNING: IN ALL AREAS WHERE FREQUENT WASH DOWNS OCCUR, STAND OFF BLOCK MUST BE INSTALLED.
ANY MATERIAL EXTRAPOLATED FROM THIS DOCUMENT OR FROM WHEELOCK MANUALS OR OTHER
DOCUMENTS DESCRIBING THE PRODUCT FOR USE IN PROMOTIONAL OR ADVERTISING CLAIMS, OR FOR ANY
OTHER USE, INCLUDING DESCRIPTION OF THE PRODUCT'S APPLICATION, OPERATION, INSTALLATION AND
TESTING IS USED AT THE SOLE RISK OF THE USER AND WHEELOCK WILL NOT HAVE ANY LIABILITY FOR SUCH
USE.
Limited Warranty
Wheelock products must be used within their published specifications and must be PROPERLY specified, applied, installed, operated,
maintained and operationally tested in accordance with these instructions at the time of installation and at least twice a year or more
often and in accordance with local, state and federal codes, regulations and laws. Specification, application, installation, operation,
maintenance and testing must be performed by qualified personnel for proper operation in accordance with all of the latest National
Fire Protection Association (NFPA), Underwriters' Laboratories (UL), Underwriters’ Laboratories of Canada (ULC), National
Electrical Code (NEC), Occupational Safety and Health Administration (OSHA), local, state, county, province, district, federal and
other applicable building and fire standards, guidelines, regulations, laws and codes including, but not limited to, all appendices and
amendments and the requirements of the local authority having jurisdiction (AHJ). Wheelock products when properly specified,
applied, installed, operated, maintained and operationally tested as provided above are warranted against mechanical and electrical
defects for a period of three years from date of manufacture (as determined by date code). Correction of defects by repair or
replacement shall be at Wheelock's sole discretion and shall constitute fulfillment of all obligations under this warranty. THE
FOREGOING LIMITED WARRANTY SHALL IMMEDIATELY TERMINATE IN THE EVENT ANY PART NOT FURNISHED BY
WHEELOCK IS INSTALLED IN THE PRODUCT. THE FOREGOING LIMITED WARRANTY SPECIFICALLY EXCLUDES ANY
SOFTWARE REQUIRED FOR THE OPERATION OF OR INCLUDED IN A PRODUCT. WHEELOCK MAKES NO
REPRESENTATION OR WARRANTY OF ANY OTHER KIND, EXPRESS, IMPLIED OR STATUTORY WHETHER AS TO
MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR ANY OTHER MATTER.
USERS ARE SOLELY RESPONSIBLE FOR DETERMINING WHETHER A PRODUCT IS SUITABLE FOR THE USER'S PURPOSES,
OR WHETHER IT WILL ACHIEVE THE USER'S INTENDED RESULTS. THERE IS NO WARRANTY AGAINST DAMAGE
RESULTING FROM MISAPPLICATION, IMPROPER SPECIFICATION, ABUSE, ACCIDENT OR OTHER OPERATING
CONDITIONS BEYOND WHEELOCK'S CONTROL.
SOME WHEELOCK PRODUCTS CONTAIN SOFTWARE. WITH RESPECT TO THOSE PRODUCTS, WHEELOCK DOES NOT
WARRANTY THAT THE OPERATION OF THE SOFTWARE WILL BE UNINTERRUPTED OR ERROR-FREE OR THAT THE
SOFTWARE WILL MEET ANY OTHER STANDARD OF PERFORMANCE, OR THAT THE FUNCTIONS OR PERFORMANCE OF
THE SOFTWARE WILL MEET THE USER'S REQUIREMENTS. WHEELOCK SHALL NOT BE LIABLE FOR ANY DELAYS,
BREAKDOWNS, INTERRUPTIONS, LOSS, DESTRUCTION, ALTERATION, OR OTHER PROBLEMS IN THE USE OF A PRODUCT
ARISING OUT OF OR CAUSED BY THE SOFTWARE.
THE LIABILITY OF WHEELOCK ARISING OUT OF THE SUPPLYING OF A PRODUCT, OR ITS USE, WHETHER ON
WARRANTIES, NEGLIGENCE, OR OTHERWISE, SHALL NOT IN ANY CASE EXCEED THE COST OF CORRECTING DEFECTS
AS STATED IN THE LIMITED WARRANTY AND UPON EXPIRATION OF THE WARRANTY PERIOD ALL SUCH LIABILITY
SHALL TERMINATE. WHEELOCK IS NOT LIABLE FOR LABOR COSTS INCURRED IN REMOVAL, REINSTALLATION OR
REPAIR OF THE PRODUCT BY ANYONE OTHER THAN WHEELOCK OR FOR DAMAGE OF ANY TYPE WHATSOEVER,
INCLUDING BUT NOT LIMITED TO, LOSS OF PROFIT OR INCIDENTAL OR CONSEQUENTIAL DAMAGES. THE FOREGOING
SHALL CONSTITUTE THE SOLE REMEDY OF THE PURCHASER AND THE EXCLUSIVE LIABILITY OF WHEELOCK.
IN NO CASE WILL WHEELOCK'S LIABILITY EXCEED THE PURCHASE PRICE PAID FOR A PRODUCT.
Limitation of Liability
WHEELOCK'S LIABILITY ON ANY CLAIM OF ANY KIND, INCLUDING NEGLIGENCE AND BREACH OF WARRANTY, FOR
ANY LOSS OR DAMAGE RESULTING FROM, ARISING OUT OF, OR CONNECTED WITH THIS CONTRACT, OR FROM THE
MANUFACTURE, SALE, DELIVERY, RESALE, REPAIR OR USE OF ANY PRODUCT COVERED BY THIS ORDER SHALL BE
LIMITED TO THE PRICE APPLICABLE TO THE PRODUCT OR PART THEREOF WHICH GIVES RISE TO THE CLAIM.
WHEELOCK'S LIABILITY ON ANY CLAIM OF ANY KIND SHALL CEASE IMMEDIATELY UPON THE INSTALLATION IN THE
PRODUCT OF ANY PART NOT FURNISHED BY WHEELOCK. IN NO EVENT SHALL WHEELOCK BE LIABLE FOR ANY
CLAIM OF ANY KIND UNLESS IT IS PROVEN THAT OUR PRODUCT WAS A DIRECT CAUSE OF SUCH CLAIM. FURTHER, IN
NO EVENT, INCLUDING IN THE CASE OF A CLAIM OF NEGLIGENCE, SHALL WHEELOCK BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE PRECEDING LIMITATION MAY NOT APPLY TO ALL PURCHASERS.
03/04