Wilbur Curtis Sencotel GRANITIME S/FF User manual

Page 1
2. Unpack the unit. Keep the original packaging
materials in the event the unit needs to be returned
to the manufacturer.
3. Locate the legs, packaged inside the bowls. Thread
them into the mounts on the bottom of the unit.
Hand tighten into place.
continued...
SETUP INSTRUCTIONS
System Requirements
• Electrical: See the WIRING DIAGRAMS in this
manual or visit www.wilburcurtis.com for your
model. The electrical outlet must be in a location
that allows the unit to be easily disconnected for
service or cleaning.
• Operating Temperature: 68 to 90°F (20 to 32°C).
1. Select the location. The unit must be installed
indoors away from sources of moisture and heat.
The clearances shown are the minimum distances
from obstructions, between CFB units and other
equipment, required for proper operation. Do not
obstruct the ventilation grills on the back and sides.
Locate the unit on a secure, level surface. Install the
unit for easy removal if service is needed.
Symbols:
WARNING/CAUTION – To advise about conditions that may result in property damage,
personal injury or death
WARNING:
IMPORTANT - Notes about proper operation
Models covered
•GRANITIME 2-S/FF
•GRANITIME 3-S/FF
Model CFB2 shown
Important Safeguards/Symbols
• This equipment is designed for commercial use only.
•To reduce the risk of re or electric shock, DO NOT open service panels. There are no user
serviceable parts inside. Any servicing other than cleaning and routine maintenance should
be performed by an authorized Wilbur Curtis Co., Inc. service technician. Refrigeration
equipment must be serviced by a licensed, certied, refrigerant technician.
• Do not install a damaged unit or a unit with a damaged power cord.
• Clean this appliance according to the CLEANING section of this manual before using it for
the rst time. Clean this appliance daily according to the CLEANING section.
• Keep hands and other items away from moving parts during operation.
• Dispose of refrigeration equipment and refrigerants in accordance with current local
environmental protection regulations and laws. This applies to an appliance that is being
replaced and to this unit, when it has reached the end of its service life. DO NOT dispose of
refrigeration equipment in a landll or urban waste. Contact your local governing authorities
for information on disposal requirements.
WILBUR CURTIS CO., INC.
Montebello, CA 90640
For the latest information go to
www.wilburcurtis.com
Phone: [phone]
IMPORTANT: Installer:
Observe all codes and
ordinances.
WARNING:
Read and follow the
setup instructions
before attempting to use this
appliance. Failure to follow these
instructions can result in injury
and/or void the warranty.
EXCESSIVE WEIGHT
WARNING: Due
to weight, this unit
requires a minimum of two
people to lift or reposition.
IMPORTANT: RMAs will not be accepted unless the unit
is packaged in the original packaging material.
Sencotel GRANITIME S/FF
Service Manual – Frozen Beverage Dispenser
READ AND SAVE THESE INSTRUCTIONS
3
60" min.
(150 cm)
4" min.*
(10 cm)
4" min.*
(10 cm)
4" min.*
(10 cm)
CFB
frozen
beverage
dispenser
*9" (23 cm) recommended
1

Page 2
Sencotel GRANITIME 3-S/FF
4. Level the unit left to right and front to back by rotating the feet on the bottom of the
legs.
5. Locate the drip trays, packaged inside the bowls. Position the drain hose in the
opening in the top of each tray. Then, insert the tabs on the back of the drip tray
into the holes on the front of the chassis. Push down gently to secure in place.
6. Prepare to install the dispensing levers by removing the handles from the taps.
Push in on the top of the handle with your thumb while pulling up on the bottom
with your index nger.
7. Locate the dispensing levers, packaged inside the bowls. Install them on the tap
handles. While pulling outward on both sides of the base of the dispensing lever,
insert the pins on the bottom of the handle into the base holes on the lever.
8. Lubricate the tap mounting slots using food grade lubricant.
9. Prepare the tap handle assembly for attachment. Lubricate the red rubber gasket
on the back of the tap handle assembly with food grade lubricant and insert it into
the tap hole on the bottom of the bowl. Line up the middle pins on the handle with
the mounting slots.
10. Attach the tap handle assembly. Push in with your thumb on the center of the
handle until the tap handle assembly pops into place.
SETUP INSTRUCTIONS (CONT.)
WARNING: Use the
leveling legs to level
the dispenser only. Do
not use them to adjust unit height.
Do not extend them higher than
necessary.
4
8
7
6
Drain hose
5
Lever
Base
Handle
10
Push here
9
Spring must be
between mounts
Mount
Line up as
shown
Red plug
(lubricate)
CLICK HERE to view and purchase
Sencotel GRANITIME parts

Page 3
Service Manual - Frozen Beverage Dispenser
SETTING THE TIMER CLOCK*
1. With the main power switch off, turn the outer wheel on the timer
clockwise until the correct time (AM or PM) lines up with the arrow on
the clock face.
2. Turn on the main power switch to start the clock.
TIMER OPERATION*
Use the timer to start the unit automatically. This feature allows you to
pour the mix in ahead of time and have the slush ready to serve at the
programmed time (unattended operation). The timer determines when
the unit is in standby (night) mode or freeze mode. In standby mode the
mixture is kept cool, but does not freeze.
The unit comes from the factory set for manual (non-timer) operation.
When all of the timer tabs are ipped outward (see diagram, right), the
timer is disabled and the unit will freeze slush any time the refrigeration
switch is set to ON (|).
Setting Up the Timer
1. With the main power switch off, ip the timer tabs next to the time
marks on the timer to either the standby or freeze position. The unit
will operate in the mode selected during the corresponding time
period.
2. Check to make sure the clock is set to the current time, then turn ON
(|) the main power switch.
*Models CFB2 and CFB3 only.
CAUTION:
• Set the timer only with the main power switch in the
OFF () position .
• Turn the timer wheel only in the clockwise direction.
• Do not set the timer using any kind of tool.
Turn outer wheel
clockwise to set
Timer tabs
Timer tab in
freeze position
Timer tab
in standby
(night)
position
Timer Side View
Clock Set to 9:05 PM
IMPORTANT: The clock/timer is equipped with a backup circuit
and continues to keep time for 10 to 15 minutes after power is
interrupted. If the power cord is disconnected or the main power
switch is turned off for a longer period of time, the clock will need
to be reset when power is restored.
12
12
11
10
9
8
7
5
4
3
2
1
PM
12
11
10
9
8
7
5
4
3
2
1
AM
9
6
3
12
12
11
10
9
8
7
5
4
3
2
1
PM
12
11
10
9
8
7
5
4
3
2
1
AM
9
6
3
11. Open the control panel door (on the right side) and make sure the
main power switch is in the OFF () position.
12. Set the timer clock according to the
instructions below.
13. Connect the unit to a grounded,
3-prong, electrical outlet with the
appropriate amperage rating. The circuit
must be protected by a suitably rated circuit breaker. Do not use an
extension cord or any type of adapter.
14. Turn ON (|) the main power switch.
15. Clean and sanitize the unit before using it for the rst time as
instructed in the CLEANING section. Verify that the unit is operating
properly according to the operating instructions.
Main Power Switch Location
IMPORTANT: The unit
may not operate as
desired if the timer is not
set properly.

Page 4
Sencotel GRANITIME 3-S/FF
1. Dilute and mix the slush concentrate with water in a clean container. Follow the concentrate manufacturer’s
directions. THE MIXTURE OBTAINED MUST HAVE A MINIMUM SUGAR CONTENT OF 13°Bx and less than
22°Bx (11 to 20% sugar by weight). The capacity of each mixing bowl is 3 gallons (12 liters).
2. With the mixing switch in the OFF () position, remove the mixing bowl lid from the desired bowl and hang
it on the side. Pour in the mix up to, or below the MAX LEVEL indicator. The minimum level is just above the
plastic mixing auger.
3. Replace the mixing bowl lid.
4. Make sure the main power switch is ON (|). Push (|) on the mixing switch for the desired mixing bowl to turn
on the mixer.
5. Push (|) on the refrigeration switch for the desired mixing bowl to begin freezing. NOTE: On units equipped
with a timer, when the refrigeration switch is in position (|), the unit will freeze the slush mixture provided
the timer is set to freeze for the current time (see Setting the Timer). Standby mode, position (||) on the
refrigeration switch, may be used to put the unit in standby mode manually. This mode saves energy, keeping
the mixture cool without freezing.
6. Once the mixture is frozen (40 to 90 minutes), pull out on the top of the dispenser lever or push the bottom of the lever to dispense.
OPERATING INSTRUCTIONS
Concentrate
Water
1
45
3
or
6
WARNING:
• Keep body parts and other items clear of the inside of the mixing bowl when the main power switch is
ON (|). Keep the mixing switch in the OFF () position whenever the mixing bowl lid is removed.
• To prevent damage to the unit and for good results, use only slush mixtures with the required sugar
content (see below). Do not use the machine to freeze water without slush concentrate added. Never
pour hot liquids (above 77°F/25°C) into the mixing bowl. This unit is not for use with milk/dairy based
products.
• Do not ll the mixing bowl higher than the MAX LEVEL indicator.
MAX
LEVEL
2
Mixing
Refrigeration

Page 5
Service Manual - Frozen Beverage Dispenser
Lid Lights
Push (|) on the light
switch to turn on the
integral lid lights.
Adjusting Slush Thickness
Use the adjustment screws
at the back of each mixing
bowl to adjust slush thickness.
The recommended (factory
default) setting is 2. Insert a
at blade screwdriver into the
adjustment hole as shown and
turn to adjust. The indicator on
the back will move to indicate
the thickness level. The higher
the number the thicker the
slush will be.
IMPORTANT: When the
thickness level is set to
higher levels, (around 4) the
lid should be fastened to prevent
it from coming off during operation.
OPERATING INSTRUCTIONS (CONT.)
Periodic maintenance
Have the unit checked periodically (at least once a year) by a qualied technician to ensure proper operation.
WARNING:
• To avoid personal injury, disconnect the power cord before cleaning. Wear protective glasses and
gloves.
• Never spray water on the unit to clean it.
• Do not use cleaning liquids, compounds or powders containing chlorine (bleach), solvents, scouring
powder, ammable materials or corrosives. These products promote corrosion and will damage the
surfaces. USE OF THESE PRODUCTS WILL VOID THE WARRANTY.
• DO NOT immerse the unit or parts in water or any other liquid, unless specically instructed to do so.
Do not wash any of the components in a dishwasher. Hand or air dry the parts only.
CLEANING
Daily Cleaning
It is recommended to clean and sanitize all of the bowl assemblies at least once a day according to the following steps. These
operations may need to be performed more frequently based on the mix used. Contact the concentrate supplier for more details. If
the machine is not used continuously throughout the day, wipe the tap areas with a clean cloth and sanitizing uid. If the dispenser
has not been used for a long period of time, clean the unit before returning it to use.
1. For cleaning, prepare a mild solution of detergent and warm water.
Empty the Drip Trays
The drip trays should be emptied and cleaned
every day and drained every time the red full
indicator pops up. They must also be removed
before emptying the bowl.
2. Lift each drip tray up and out.
3. Wash the trays and grills with the detergent
solution. Hand dry all of the components,
then reinstall the grills. Set the trays aside
and reinstall at the end of the daily cleaning
process.
Full indicator
MAX
4
3
2
1
MAX
4
3
2
1
MAX
4
3
2
1
Back
2