Wood Designs 991519 User manual

991519 ASSEMBLY INSTRUCTIONS
For assistance, call: Customer Service 1-800-247-8465
Parts:
Step 1: Attach Table to Walls.
Align pre-drilled holes. Use Torx
driver and (6 qty) 2” T20 screws to
attach Table to each post.
Hardware:
(2) Walls
Table
Ridge Cap
Assembly
Step 2: Attach Roof pieces together.
Aligning pre-drilled holes in cleat, use
driver to secure roof pieces together
using (8 qty) 1 1/4” T20 screws. (4) for
each cleat.
*Each wall will have (3)
pilot holes drilled to attach
table on opposing ends.
T20 Torx Driver (Not Included)
*Mirrored
Holes
Holes
(4) Ground stakes w/ hardware
(4) 1 3/4” T20 screws (32) 1 1/4” T20 screws
(6) 2” T20 screws
(2) Roof Cleats
(2) Roofs

Step 5: If unit is not already upright, set unit
upright, resting edges of walls on floor. Set in
final resting place and line up ground stakes to
each corner post. Using a 1/16” drill bit (not
included) drill pilot holes for the screws used to
attach the stakes to the posts. Use (8) 1 1/4”
torx screws to attach the ground stakes to the
outside of the four corner posts. Tighten all
screws snugly. DO NOT OVER-TIGHTEN. DO
NOT DRILL. Assembly is now complete.
Step 4: Attach Roof to Walls. With
help from a peer, lift the roof assembly
onto the walls. Attach roof assembly to
each of the (4) supports using (2) 1
1/4” T20` screws. All holes pre-drilled.
Do not drill. Screws go in from under-
neath so as not to be visible from
above.
Step 3: Attach Ridge Cap. Ridge Cap is made up of two components. L-shaped piece lays
over lattice material. Trapezoidal piece goes underneath and is secured using (2 qty) 1 3/4”
T20 screws on each end. Put these two pieces in their corresponding places and secure to-
gether with (8 qty) 1 1/4” T20 screws. Together the L-shaped & the Trapezoidal Pieces,
sandwich the open end of lattice material in place. Hole placement may differ from picture.
All holes needed are drilled. Do not drill.
For assistance, call: Customer Service 1-800-247-8465