XCM Shell User manual

Wireless shell with LED analog stick_installation.1
1.installation parts.
2.The RT and LT buttons.
XCM Shell With LED Thumbsticks Guide
Tuesday, November 02, 2010
8:06 AM
XCM Shell w LED Page 1

3.As shown in the diagram, install the RT and LT buttons step by step.
4.Remove the double-side tape.
XCM Shell w LED Page 2

4.Remove the double-side tape.
5.Stick the PCB to the these 2 places.
6.Soldering this 4 points.
XCM Shell w LED Page 3

6.Soldering this 4 points.
7.Follow the direction of the arrow indicated to lay down the wires.
Pasted from <http://www.xcm.cc/wireless_shell_with_led_analog_stick_installation.htm>
XCM Shell w LED Page 4

Wireless shell with LED analog stick_installation.2
8.Using the adhesive tape stick the cable to this position.
9.As shown in the photo, soldering this 2 wires.
XCM Shell w LED Page 5

9.As shown in the photo, soldering this 2 wires.
10.Plug the power cord to this socket.
XCM Shell w LED Page 6

10.Plug the power cord to this socket.
11.As shown in the diagram, push the back of on-live button close to this point,
make sure the button working properly before closing the controller shell.
12.Close the controller bottom, put on the 7 screws then cover the battery pack
back to the place.
XCM Shell w LED Page 7

back to the place.
13.LED light button (on/off the LED light).
Pasted from <http://www.xcm.cc/wireless_shell_with_led_analog_stick_installation.2.htm>
XCM Shell w LED Page 8

Pasted from <http://www.xcm.cc/wireless_shell_with_led_analog_stick_installation.2.htm>
XCM Shell w LED Page 9