Xiaomi Mi phone User manual



To users:
FCC Statement
Thanks for choosing the Mi Laser Projector 150". Read this manual carefully before use, and retain it for future reference.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition
without restriction.
FCC ID: 2AO2D-MJJGYY02FM
Bluetooth Remote Control FCC ID: 2AO2D-YKF429-004
WEEE
WEEE Disposal and Recycling Information Correct Disposal of this product. This marking indicates that this product should not be disposal with
other household wastes throughout the EU.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsible to promote the
sustainable reuse of materials resources. To return your used device, please use the return and collection systems or contact the retailer where
the product was purchased. They can take this product for environmental safe recycling.
3

FDA
CE
IC
Complies with 21 CFR1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007.
We Fengmi (Beijing) Technology Co., Ltd., hereby, declares that this equipment is in compliance with the applicable Directives and
European Norms, and amendments.
For MJJGYY02FM
Bluetooth Frequency range: 2400 MHz-2483.5 MHz
Maximum Output Power: 8.89 dBm
Wi-Fi 2.4G Frequency range: 2400 MHz-2483.5 MHz
Maximum Output Power: 18.26 dBm
Wi-Fi 5G Frequency range: 5150 MHz-5350 MHz
Maximum Output Power: 18.60 dBm
Frequency range:5470 MHz-5725 MHz
Maximum Output Power: 18.72 dBm
The WLAN function for this device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range.
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisee
aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et. (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement.
Note:
- The distance required between a person and the projector must be ≥7.9 in.
4







Power Indicator
System status prompts from the device's indicator light (a white light source):
- The system will automatically turn on once the power cord is connected.
- The indicator will flash during the shutdown process.
- The indicator light will remain on after accessing the system.
- The indicator light will disappear after the system is turned off.
Power Indicator
11

Projection Range and Screen Dimensions
Determines the distance required between the projector and the screen based on the size desired.
Projector Screen
Dimensions (SD) Projector Distance (D) Relative Height (H)
80"5.5 in 11.4 in
90"7.5 in 12.6 in
100"9.5 in 13.8 in
120"13.4 in 16.1 in
150"19.3 in 19.7 in
SD
D
H
Projector Screen
Projector Screen
Note:
- The dimensions in the above table are approximate values and may vary sl ghtly with the actual values. Please use only as a reference.
12








Technical Specifications
Basic Information
Model Mi Laser Projector 150"
Dimensions 16.1×11.5×3.5 in
Weight 15 2 lbs
Basic Functions Lens focus Motor focus
Dust cover Glass Dust Cover
Optical Parameters
Display technology 0.47"DMD
Light technology ALPD
Standard resolution Full HD (1920×1080)
Projection Parameters
Frame refresh rate 60/120 Hz (1920×1080@60 Hz is recommended for best results)
Lens focal length 0.7 in
Projection ratio (TR) 0.233
Picture size 80"-150"
Keystone correction 8-Point Keystone Correction, 4-Point Keystone Correction
System Parameters
CPU T962X Cortex-A53
Four 1.5 GHz cores/64 bit
RAM 2G DDR4
Built-in storage 16GB eMMC high speed flash memory
System Software
Operating system Google Android System
Compatibility Google Android Player
APP Store Google Play Store
AV wireless transmission Google Cast
Brightness mode Dynamic, movie, standard
Dynamic image Supports HDR
Audio Speaker stereo Full range×2 + high-frequency×2 (Total ≈ 30 w)
20
Other manuals for Mi phone
13
Table of contents
Other Xiaomi Projector manuals