Zhejiang Third Net Technology Co. TN-IVS-8000 User manual

Intelligent Vehicle Network Gateway
TN-IVS-8000
User Manual
Zhejiang Third Net Technology Co., Ltd

Intelligent Vehicle Network Gateway TN-IVS-8000
1
1. Product profiles
TN-IVS-8000 is an intelligent vehicle network gateway produced by
Zhejiang Third Net Technology Co., Ltd. With multiple functions it supports
3G/4G mobile networks, WIFI network , GPS and multimedia center. Data
exchanging between mobile and WIFI networks can let customer using WIFI to
browse website in the bus. Build in multimedia center provides plenty of films,
music, magazines, games, advertising and also other information.
The combination of GPS and mobile network provides a powerful
management function, such as real time tracking, remote managing, scheduling,
first aid, video monitoring, emergency alarm push and so on.
As special designed for the vehicle, the equipment has strong anti vibration,
surge protection and power protection abilities.

Intelligent Vehicle Network Gateway TN-IVS-8000
2
2. Product Specifications
2.1. Hardware
Devise size: length / width / height (mm) 235 / 191 / 46
2.2. Front panel
Composed of 6 parts
A) Ethernet interface : 5 interfaces, 1 WAN; 4 LAN
B) SD card slot
C) SIM card slot
D) One USB interface
E) A reset push button
* SD and SIM slots are covered by a plastic plate to prevent loss
2.3. Rear panel
A) A power connector
B) 5 antenna connectors
a) 1 GPS connector
b) 2 WIFI connectors
c) 2 of 3G/4G connectors
3. Installation
3.1. Equipment is in power down statement
3.2. Open the plastic plate to insert SIM card and SD card ( if needed)

Intelligent Vehicle Network Gateway TN-IVS-8000
3
3.3. Connect 4G , WIFI and GPS antennas
3.4. Connect power cable, the voltage is 9-36V
3.5. Connect Ethernet cable (if needed)
3.6. Install the equipment to the bus ( see installation manual)
4. Start up
4.1. Turn on power, when 2 LEDs are light , the equipment has been working
well
4.2. Check WIFI hot spots, find the SSID of “ IVS8000-i” ( i : 1 ~ n)
4.3. Log in the hot sport ( currently no password required),
4.4. Web browsing
5. Antenna
5.1. 4G Antenna manufacturer,type,and Electrical Characteristics
manufacturer :Shanghai Roadeo Technology Co., Ltd.
Part number : LTE_PM800W1_J1M
Electrical Characteristics
1
Frequence Range
FDD LTE:B1/B3
TDD LTE:B38/B39/B40/B41
TDSCDMA:B34/B392400-2500MHz
WCDMA:B1
CDMA2000 1x/EVDO:BC0
GSM:900/1800MHz
2
V.S.W.R
2:1
3
Impedance
50 ohm
4
Gain(Typical)
1dBi @FDD LTE:B1/B3
1 dBi @TDD LTE:B38/B39/B40/B41
1 dBi @TDSCDMA:B34/B392400-2500MHz

Intelligent Vehicle Network Gateway TN-IVS-8000
4
1 dBi @WCDMA:B1
1 dBi @CDMA2000 1x/EVDO:BC0
1 dBi @GSM:900/1800MHz
5
Azimuth
Omni-direction
6
Polarization
Linear polarization
5.2. 2.4G Wifi Antenna manufacturer,type,and Electrical Characteristics
manufacturer :Shanghai Roadeo Technology Co., Ltd.
Part number : WIFI_PM900W1_J5M
Electrical Characteristics:
1
Frequence Range
WIFI:2400-2500MHz
2
V.S.W.R
2:1
3
Impedance
50 ohm
4
Gain(Typical)
3 dBi
5
Azimuth
Omni-direction
6
Polarization
Linear polarization
5.3. GPS Antenna manufacturer,type,and Electrical Characteristics
manufacturer :Shanghai Roadeo Technology Co., Ltd.
Part number : DAM1575A4A1LC01_G3_J1M
Electrical Characteristics

Intelligent Vehicle Network Gateway TN-IVS-8000
5
1
Frequence Range
1575.42MHz±1.02 MHz
2
V.S.W.R
1.5:1
3
Impedance
50 ohm
4
Gain(Typical)
5dBic Based on7×7cm ground plane
5
Band Wodth
> 10 MHz
6
Polarization
RHCP
6. Safety warning
This radio transmitter (identify the device by certification number or model number if Category II) has been
approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain
indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that
type, are strictly prohibited for use with this device.

Intelligent Vehicle Network Gateway TN-IVS-8000
6
FCC
changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
20cm
between the radiator & your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.

Intelligent Vehicle Network Gateway TN-IVS-8000
7
IC
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Cet appareil est conforme aux CNR exempts de licence d'Industrie Canada. Le
fonctionnement est soumis aux deux conditions suivantes:
(1) Cet dispositif ne peut causer des interférences; et
(2) Cet appareil doit accepter toute interférence, y compris les interférences qui peuvent
causer un mauvais fonctionnement de l'appareil.
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102
and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF
exposure and compliance.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de
RSS 102 etla conformité à l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information
canadienne surl'exposition et la conformité de rf.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter. This equipment should be installed and operated with a minimum distance
of 20 centimeters between the radiator and your body. Cet émetteur ne doit pas être
Co-placé ou ne fonctionnant en même temps qu'aucune autre antenne ouémetteur. Cet
équipement devrait être installé et actionné avec une distance minimum de 20 centimètres
entre le radiateur et votre corps.
This radio transmitter (identify the device by certification number or model number if
Category II) has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.