a'-tek a1303 User manual

a1303 instruction manual
home zone:
a) setting the time
1. pull the crown out to the 1st click position.
2. turn the crown to set hour and minute hands.
3. after the time has been set, push the crown back to the normal position
local zone:
a) setting the time
1. pull the crown out to the 2nd position.
2. turn the crown to set hour and minute hands.
3. when the crown is pushed back to the normal position, small second hand begins to run.
b) setting the date
1. pull the crown out to the 1st position.
2. turn the crown counter-clockwise to set the date.
*if the date is set between the hours of around 9:00 pm and 1:00 am, the date ma not change on the
following da .
3. after the date has been set, push the crown back to the normal position.
c) using the chronograph
this chronograph is able to measure and displa time in 1/1 second united up to maximum of 59 minutes 59
seconds.
the chronograph second hand keeps continuousl for 59 minutes 59 seconds after starting.
measuring time with the chronograph
1. the chronograph can be started and stopped each time pusher "a" is pressed.
2. pressing pusher "b" resets the chronograph and the chronograph second hand and chronograph minute
hand return to zero position.
d) chronograph reset (incl. after replacing battery)
this procedure should be performed when the chronograph second hand does not return to zero position
after the chronograph has been reset, and including after the batter has been replaced.
1. pull the crown out to the 2nd position.
2. press pusher "a" to set the chronograph second hand to the zero position. the chronograph hand can
be advanced rapidl b continuousl pressing pusher "a".
3. once the hand have been zeroed, return the crown to the normal position.
* do not push crown to normal position while the chronograph second hand returns to zero position. it
stops on the wa when crown are returned to normal position and its position is recognized as zero
position.