Abax MINI 2 User manual

EASY
INSTALLATION
Watch how to install
your MINI 2:
abax.com/installations
Simply Connected
Simply Connected
FCC Statement This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of t he FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
INSTALLATION GUDIE
abax.com
MINI2

IC Caution The device meets the exemption from the routine evaluation limits in
section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can
obtain Canadian information on RF exposure and compliance. This device contains
licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the
following two conditions: (1) This device may not cause interference. (2) This device
must accept any interference, including interference that may cause undesired operat-
ion of the device. This equipment should be installed and operated with a minumum
distance of 20 cm between the radiator and your body. Le dispositif rencontre
l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS102 et la
conformité à l’expostion de RSS-102 rf, utilisateurs peut obtenir l’information cana-
dienne sur l’exposition et la conformité de rf. L’émetteur/récepteur exempt de licence
contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes : (1) L’appareil ne
doit pas produire de brouillage; (2) L’appareil doit accepter tout brouillage radio-
électrique subi, même si le brouillage est susceptible d’en compromettre le onctionne.
1
2
3 4
The ABAX MINI can be
used as a portable device
using the key-chain
accessory or mounted
in a secure area with the
included 3M mounting
tape.
The device can be used in all EU Member States.
The frequency bands and the maximum radio frequency
emission power in which this device operates are as follows:
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, ABAX AS, declares that the radio equipment is in
compliance with Directive 2014/53/EU. The full text of the
EU declaration of conformity
is available at the following
internet address:
abax.com/installations
No activation needed;
it is ready to go!
Remember to download
our apps to manage your
equipment and tools from
your phone!
Locate your units within
1 minute by scanning
with your phone.
DO YOU HAVE ANY QUESTIONS?
Our customer service is available by phone
24/7. Visit abax.com for contact information. The user should maintain a compliance distance of 10mm or greater according to SAR/RF exposure requirements.