Abeeway EU868 User manual

Micro Tracker user guide
Micro Tracker
Firmware V1.6
ABEEWAY SAS
[e-mail]
www.abeeway.com

Micro Tracker User Guide FW1.6 V1.1
Page 2 of 17
11 October 2018
Company Confidential –restricted distribution
Table of contents
1Introduction ............................................................................................................................ 3
1.1 General Description ..........................................................................................................3
1.2 Applications ...................................................................................................................... 3
2Features .................................................................................................................................. 3
3Installation .............................................................................................................................. 4
3.1 Getting started.................................................................................................................. 4
3.2 Fixation............................................................................................................................. 4
4Functioning ............................................................................................................................. 5
4.1 Main operating modes......................................................................................................5
4.2 Side operations.................................................................................................................6
4.3 User interface ................................................................................................................... 6
4.4 Geolocation strategies ......................................................................................................8
5Uplink messages......................................................................................................................9
6Remote configuration using ADA........................................................................................... 10
6.1 Operating Mode Configuration ....................................................................................... 10
6.2 Position on demand ........................................................................................................ 10
6.3 Parameters configuration................................................................................................ 10
7Downlink messages ............................................................................................................... 11
7.1 Ack Token........................................................................................................................ 11
7.2 Mode Configuration........................................................................................................ 12
7.3 Position on demand ........................................................................................................ 12
7.4 Parameters configuration................................................................................................ 12
8Specifications ........................................................................................................................ 15
8.1 Physical configuration ..................................................................................................... 15
8.2Estimated lifetime........................................................................................................... 15
8.3 Data communication support.......................................................................................... 15
8.4 Position accuracy ............................................................................................................ 16
8.5 Power management........................................................................................................ 16
9Products References.............................................................................................................. 16

Micro Tracker User Guide FW1.6 V1.1
Page 3 of 17
11 October 2018
Company Confidential –restricted distribution
1 Introduction
1.1 General Description
The Abeeway Micro Tracker is a multi-mode tracker combining GPS/Low power GPS, Wi-Fi, LoRa,
BLE radios with embedded sensors to support accurate outdoor and indoor geolocation. A button,
a buzzer and 3 LEDs are available to interface with the user. The Micro Tracker, with its small size and
long battery lifetime, is the ideal product for many tracking applications.
1.2 Applications
➢Asset tracking at fixed frequency updates or on demand.
➢Personal tracking with help button.
➢Safety monitoring for isolated workers inside facilities or in outdoor.
➢Anti-theft; Notification and location when device is moving.
➢Geofencing applications.
2 Features
➢Multiple operating modes
•Motion tracking: Get the tracker position at a given cycle when motion is detected.
•Permanent tracking: Get permanently a position of the tracker.
•Start/End motion tracking: Get position messages during motion start and end
events.
•Activity tracking: Monitor activity rate with embedded sensors.
•OFF: device stopped
➢Position on demand: Receive the tracker position only when needed (very low power
operating mode).
➢Used geolocation technologies
•GPS: Precise outdoor position.
•Low power GPS: get quick position outdoors and daylight indoor conditions.
•WI-FI: Position indoors and urban area.
➢Buzzer and LEDs
➢Temperature monitoring
➢Embedded antennas
➢LoRa™ Class A radio
➢Water-spray resistant enclosure (IP64)
Commenté [AD1]: Need to be aligned with dataheet

Micro Tracker User Guide FW1.6 V1.1
Page 4 of 17
11 October 2018
Company Confidential –restricted distribution
3 Installation
3.1 Getting started
➢Charge your device using a micro USB cable. While charging the white led is ON. When the
battery is fully charged the white LED goes OFF.
➢A long press is needed to turn ON the device (starting in motion tracking mode in standard
configuration).
➢Your network can use two activation modes:
oOTAA (Over The Air Activation) that requires the following keys to make the join: DEVEUI,
APPEUI and APPKEY for each device. (the most used)
oABP (Activation by personalization) that requires the following keys to make the join:
DEVEUI, DEVADDR and NWKSKEY for each device
➢Depending on your operator, some actions need to be done to activate the transfer of the
data through Abeeway servers. Please refer to your vendor for more information.
3.2 Fixation
The device can be attached with the provided lanyard or placed in bag, or inside an asset.
Note: the environment and orientation of the tracker can influence the radio performance. For
optimum results keep the zone around the antenna area clear from any conducting material or
magnetic field.
Blue LED
Button
Lanyard
White Charge LED
Micro USB
Antennas area

Micro Tracker User Guide FW1.6 V1.1
Page 5 of 17
11 October 2018
Company Confidential –restricted distribution
4 Functioning
4.1 Main operating modes
This section describes the different operational modes supported by the trackers.
OFF mode: The tracker is in deep low power mode. No uplinks are sent in this mode. A long button
press is required to wake it up. Three possibilities to set the tracker in OFF mode:
➢User action (long button press)
➢Low battery
➢Downlink request
Standby mode: The tracker is sending periodically short LoRa messages, called heartbeat at the
chosen period (lora_period). Device position can be obtained in this mode by using the side
operations features (see next section).
Motion tracking mode: The tracker provides positions when the device is moving. The reporting is
done at the chosen period (ul_period). The positions are acquired based on the geoloc_sensor
geolocation technology. If the device is not moving, heartbeat messages are sent regularly at the
lora_period frequency. Additional positions can be obtained by using the on-demand side
operations features.
Note: Whatever the chosen geolocation policy, the first position is always established via WI-FIWi-
Fi sent immediately after the beginning of the motion.
Permanent tracking mode: The device reports its positions at ul_period frequency regardless the
motion. It uses the geoloc_sensor geolocation technology. Heartbeat messages are sent if there are
no uplink message during lora_period seconds.
Motion Start/End tracking mode: In this mode, position messages are sent twice, at the start and
at the end of a motion (one Wi-Fi and one using the geoloc_sensor geolocation technology). The
end of the motion is detected when there is no movement detection for a period of 120 seconds.
Heartbeat messages are sent if there are no uplink message during lora_period seconds. Additional
positions can be obtained by using the on-demand side operation feature.
Activity mode: This mode sends activity reports instead of positions. The tracker focuses on
detecting movements. Each shake detection increases a counter (after applying an integration
period). The value of the counter is reported up the LoRa link at the ul_period frequency. Heartbeat
messages are sent if there are no uplink messages during lora_period seconds. Additional positions
can be obtained by using the on-demand side operations features.
Note: The accuracy of the different frequencies is not guaranteed as extra delay may be introduced
by the LoRa network duty cycle.

Micro Tracker User Guide FW1.6 V1.1
Page 6 of 17
11 October 2018
Company Confidential –restricted distribution
4.2 Side operations
Whatever the mode, optional messages can be sent according to the configuration. The side
operations can be:
Periodic position message: The device sends periodically its position at periodic_pos_period
frequency. Usually, this reporting frequency is very long. The position is sent three times (six if the
device is moving).
Position on Demand: Position requests are done via LORA downlink message. The device answers
with its current position.
Alert position: A double press on the button generates a LORA uplink message containing the
position.
Notes:
➢The geolocation strategy used in these cases is geoloc_method one.
➢The side operations can be cumulated.
4.3 User interface
4.3.1 Button management
Sequence
Action
Output
One short press
Show current mode and state
Led state pattern (see next
section)
Two short presses
Trigger an alert position
Other Led pattern (see next
section)
Any press when battery low
(short or long press)
Go to OFF mode
Buzzer melody
other Led pattern (see next
section)
One long press when device
OFF and good battery
Wake up
Other Led pattern (see next
section) only for the first wake
up after reset
One very long press (5 s) when
device ON.
Go to the OFF mode
Buzzer melody
Button down when device is
ON
Blue LED ON

Micro Tracker User Guide FW1.6 V1.1
Page 7 of 17
11 October 2018
Company Confidential –restricted distribution
4.3.2 Blue LEDs mode and state patterns
This interface output is triggered by a single short button press. It generates two main sequences
The two sequences are consecutives. The first one indicates the mode, and, is followed by the
state of the tracker. The LED behavior are provided below.
Show current mode
➢Mode Standby: No blink.
➢Mode Motion Track: One long blink.
➢Mode Permanent Track: Two long blinks.
➢Mode Motion Start/End Track: Three long blinks.
➢Mode Activity: Four long blinks.
Show current state
➢State Idle: No blink.
➢State Tracking: Two fast blinks.
4.3.3 Other blue LEDs patterns
Three fast blinks
Go to the OFF mode (Low battery)
Three slow blinks
Device starting for the first time
Long fast blink of blue LED
LORA join operation in progress
Fast blink of blue LED after two button
clicks
Device acknowledges the alert position
4.3.4 Buzzer melodies
There are three different melodies:
Melody
Meaning
Major rising scale
Device is starting
Major falling scale
Device is going to OFF mode
Low battery
Low battery detected

Micro Tracker User Guide FW1.6 V1.1
Page 8 of 17
11 October 2018
Company Confidential –restricted distribution
4.4 Geolocation strategies
4.4.1 Main operating modes
The following geolocation policies (geoloc_sensor parameter) are used when the operating mode
is either motion-tracking, permanent-tracking, or start/end tracking.
➢WI-FI only → Only WI-FI scans are used for position determination.
➢GPS only →Only the GPS is used for position determination.
➢LP-GPS only→ GPS and LP-GPS are used for position determination.
➢Multimode (WI-FI + AGPS + GPS)→ Alternate WI-FI, LP-GPS and GPS technologies on failure,
with timeout.
➢Wi-Fi-GPS only → WI-FI then GPS if Wi-Fi fails in one geolocation cycle.
➢Wi-Fi-LPGPS only → Wi-Fi then LP-GPS if Wi-Fi fails in one geolocation cycle.
➢Wi-Fi-LPGPS/ Wi-Fi-GPS → Wi-Fi-LPGPS first, then Wi-Fi-GPS if Wi-Fi-LPGPS fails until
timeout, then back to Wi-Fi-LGPS.
Note: The first position is always a Wi-Fi one whatever the chosen geolocation strategy.
4.4.2 Side operations
The following geolocation policies (geoloc_method parameter) are used for periodic-reporting or
on-demand actions.
➢Wi-Fi only → Only Wi-Fi scans are used for position determination.
➢GPS only →Only the GPS is used for position determination.
➢LP-GPS only→ GPS and LP-GPS are used for position determination.
➢Wi-Fi-GPS only → Wi-Fi then GPS if Wi-Fi fails in one geolocation cycle.
➢Wi-Fi-LPGPS only → Wi-Fi then LP-GPS if Wi-Fi fails in one geolocation cycle.

Micro Tracker User Guide FW1.6 V1.1
Page 9 of 17
11 October 2018
Company Confidential –restricted distribution
5 Uplink messages
Type of message
Content
Heartbeat message
Notify the server the tracker is operational and under LoRa coverage
Position message
GPS, low power GPS or Wi-Fi position data
Energy status message
Used by the server to estimate the battery level. Contain information
related to the power consumption
Activity Status
message
Reports the activity counter. Used only by the activity tracking operating
mode
Debug message
Internal used only
Frame pending
When additional downlink messages are available on gateway, this uplink
message is sent to trigger the sending (and speed up the configuration of
the tracker)
OFF message
Notify the move to the OFF state

Micro Tracker User Guide FW1.6 V1.1
Page 10 of 17
11 October 2018
Company Confidential –restricted distribution
6 Remote configuration using ADA
All following parameters are configurable in Abeeway Data Analyzer (ADA) application
6.1 Operating Mode Configuration
All modes can be set using ADA application:
➢Standby
➢Motion tracking
➢Permanent tracking
➢Motion start/end tracking
➢Activity tracking
➢OFF
6.2 Position on demand
Position of the tracker can be requested.
6.3 Parameters configuration
Following parameters are configurable:
➢Parameters used in the main operating modes:
✓LoRa Heartbeat: period of Lora Heartbeat messages
✓Position report: period of LoRa position messages
✓Geolocation methodology (geoloc sensor)
➢Parameters used in side operating modes:
✓Periodic position: activation, and period of LoRa position messages
✓Geolocation methodology (geoloc method)