ABI INTERIORS 11939 User manual

GO O S ENE CK WALL -MO UNTE D S W IVE L S P O UT
Dis cla imer: P ro d u c ts in th is ma n u a l mu s t by la w b e in s talled b y licen s ed an d reg is tered tra d es p eo p le in a cco rd a n ce w ith th e releva n t stan d a rds . A B I a n d th e ma n u fa ctu rer/d is trib u to r
res erve t h e rig h t to va ry s p ecif ic a tio n s o r d elete mo d els fro m t h eir ra n g e w ith o u t prio r n o tif ic a t io n . Dimen s io n s a re n o min a l mea s u remen ts o n ly. Th e in f o rma tio n lis t ed is co rrect at th e time
o f p u b lica tio n , h o w ever A B I a n d th e man u f a c tu rer/d is trib u to r ta kes n o res p o n s ib ility fo r p rin tin g erro rs. C o p yrig h t © A B I I n terio rs 2 02 2 Pty Ltd
SPECIFICATIONS
RECOMMENDED USE Domestic
MATERIAL Solid Brass
TEMPERATURE RATING Maximum continuous working temperature 75°C
If the water temperature exceeds 75°C,an approved tempering
valve must be fitted
PRESSURE RATING Recommended minimum working pressure 150kPa
Recommended maximum working pressure 500kPa
Hot and cold water inlet pressure should be equal
SUITABLE HOT WATER UNITS Storage tank: Yes
Continuous Flow: Yes
Gravity Feed: Not suitable
STANDARDS WELS 5 Star, 6L/min, T36815
AS/NZS 3718:2005
WM-022852

Using theallen key, loosen the grub screw.
NOTE: If your spout is positioned close to the bench or has taps close by - you may not beable to twist it onwith thegooseneck
spout attached - below are the steps to install your spout without hitting any obstacles.
Make sure the grub screw is loosened
enough to release the spout. Release spout
by pulling apart from the base.
This step is only necessary
2
Rotatethe body onto the water outlet (1/2
inch nipple) with teflon tape and firmly
tighten.
3Insert the gooseneck back into the body
and tighten the grub screw.
Note: Apply waterbased lubricant to the
O-ring
4
NOTE: If your spout is positioned close to the bench or had taps
close by - you may not be able to twist it on with the gooseneck
spout attached - below are the steps to install your spout with-
out hittingany obstacles.
DO NOT use crea m
cleaners or bleach
Thesesubstances are
abrasive
Regularlyclean with
mild liquiddeterge n t
or soap and water
DO NOT usecleaning
pads with abrasive
surfaces as this may
scratch the material
INSTA LLATION GUIDE
Note: This product must be installed by a licensed plumber. This is a general installation guide - there are many factors involved that
can alter the installation method. AU/NZ: For installations within Australia and New Zealand, this product must be installed in
compliance with AS/NZS 3500. UK: For installations in the United Kingdom this product must be installed in compliance with the
Water Supply (Water Fittings) Regulations and Water Supply (Water Fittings) (Scotland) Byelaws. Other: For installations outside
these countries, this product must be installed in compliance with the standards in your respective country.