acrilan Professional Vapor X15 Technical specifications

Manual
for installation and use
Vapor
X9
X15
Vapor
Professional
X15

- 2 -
CAUTION!
The installation must be eected by person-
nel possessing the technical and professional
qualications required by the national regu-
lations and specications in force in this eld.
The manufacturer declines all liability for
events arising from incorrect installation or
operation of the tub.
The product is designed for indoor use in
bathrooms, and must not be installed in
the open.
Always power off the product (omnipolar
switch in the OFF position) when main-
tenance is to be performed on electrical
components.
The guarantee conditions are listed in the
guarantee certicate.
ELECTRIC
SAFETY
The product is class “I” appliance.
They must be xed securely and connected
sturdily to the mains and to the earthing and
unipotential systems.
The manufacturer accepts no liability if
the hydraulic and electrical circuits are not
in compliance with EN safety standards.
The building’s electrical circuit must be
in compliance with EN safety standards
and protected by a standards-approved
dierential switch (safety cut-out) with a
dierential value of 30mA.
The cut-out must be periodically tested for
correct operation.
The earthing system must have a resistance
less than 4 ohm.
The product is provided with an unipotential
attachment terminal suitable for receiving a
6 sq.mm 2.5 cable to be used to obtain the
unipotentiality of the metal masses.
The connection to the electrical mains must
be permanent and made with a cable that is
not lighter than type H05 V V-F tri-polar, with
a nominal section of 3x2.5 mm2. It must be
intercepted by an omnipolar switch with
opening of contacts of at least 3.5 mm sui-
table for voltage of at least 230/400 V and a
current of 16 A. It should if possible be located
outside the room and distant from locations
where it might come into contact with water.
CONNECTING THE
EQUIPOTENTIAL CIRCUIT
Provide equipotential connection of the
metallic masses extraneous to the shower
booth by using the earth equipotential
contact.
Arrange the cable outlet near the electrical
power supply.
SAFETY RULES
FOR BATHROOMS
Sockets, lights, switches and other electric
devices must be installed outside the danger
zones as laid out by the Laws and interna-
tional standards for bathrooms.
Switches and other electric devices must be
situated in areas that cannot be reached by
the person using the shower booth.
It is strictly prohibited to touch, handle or
switch-on electric appliances while using the
shower booth.
Electrical appliances positioned in the zones
surrounding the shower box must be securely
xed in position to prevent them falling into
the shower box.
THE PRODUCER DECLINES
ANY RESPONSIBILITY IF :
The Laws and national standards regarding
earthing and electric systems for the product
are not respected.
The Laws and national standards in force
regarding safety for bathrooms are not
respected.
The instructions contained in this manual are
not adhered to.

- 3 -
IMPORTANT !!
Consult the technical data sheet of the
shower booth to be installed.
For the system to operate correctly the feed
water must not contain impurities (sand,
rust, etc.) and must have a pressure ranging
from 1.5 to 3 bar.
We suggest the installation of a 100
micron feed water lter and of a water
softener.
Before positioning the shower box, it is the
duty of whoever assembles the product to
check that all the connections are watertight.
This guarantee is not valid if there are
leaks after the product has been installed.
SAFETY
DISTANCES
Shower areas, saunas, bathrooms, swimming
pools and the surrounding areas are classi-
ed by EN safety standards as special zones,
since the humidity and dampness associated
with these areas can make them extremely
dangerous.
The standards specify four clearly-dened
areas:
zone 0, 1, 2 and 3.
The omnipolar switch with opening of
contacts of at least 3.5 mm must be located
outside of these zones, distant from possible
contact with water.
The limits of the various danger zones may be
modied by the presence of walls, protective
panels and xed insulating walls which limit
access to the tub or to the shower plate.
In this case, the area is delimited by taking a
piece of string whose length is that of the area
and winding it around the wall to the opposite
side. The path taken by the end of the string
marks the danger zone.
The zones that are external to the four danger
areas are considered to be normal.
PRECAUTIONS
The material used for the construction of the
shower booth is extremely tough and durable,
which is demonstrated by the widespread use
of this material in many industries.
However, this material may be damaged by
certain chemical substances such as acetones
and solvents in general, and stained by
alcohol-based liquids if these are not removed
immediately.
For this reason, it is advisable to protect the
tub with paper or cardboard (the packing
cartons may also be used) during installation,
in order to ensure that no abrasive substances
or paint come into contact with the surface.
It is also advisable to avoid placing tools on
the surface of the shower plate.
Before installing the bath, check it with
care.
Any damage of defects found after the
bath has been installed will not be covered
by the guarantee.
Immediately on delivery, check that the ap-
pliance is in perfect condition and that the
packaging is not damaged in any way.
When moving the hydromassage tub, always
grip the edges or the frame. Ensure that the
pipes are not damaged when moving the tub.
Never lift or move the column by its pipes
(or by the multipurpose holder).












- 4 -

17
50 cm
n°2
A
B
C
n°2
n°2
Ø5x16
n°2
D
Ø5x16
Ø6
TC Ø4,2x38
Display
OK!
IMPORTANT
!
80 mm
120 mm
tools kit
predispositions

- 5 -
POSITION
1
POSITION
2
230/400 Volt
230/400 Volt
temperature
probe
steam
dispenser
Display
100
230V
400V
water
outlet (1/2”)
tube for
cables
water
descarge
steam
tube
(3/4”)
230
NO SIPHON
CAUTION!
NO!
predispositions

- 6 -
1
3
Adapter
2
assembly sequence

- 7 -

230 V
400 V
2
1
x2
x2
TC Ø4,8x16
Ø5,2x38
4
Ø8
x2
3

- 8 -
x2
Ø3,9x9,5
3
4
1
2
400V
230V
400V
230V
water
outlet (1/2”)
tube for
cables
water
descarge
steam
tube
(3/4”)


230V
yellow
green
blue
brown
400V




brown
black
yellow
green
blue
grey


- 9 -
FEATURES
This keypad features “touch
screen” technology to control 4
functions:
- ON/OFF
- Turkish bath
- Chromotherapy
- Temperature
Illuminated ring:
Increases or decreases the “val-
ues” of the functions.
Simply slide a nger inside and
move it clockwise or anti-clock-
wise.
ON - OFF
Display
Chromotherapy
Turkish bath
Illuminated ring
Temperature
keyboard
Illuminated ring
ON/OFF
When the shower enclosure is not in opera-
tion, the display and function symbols on
the keypad are turned o.
The keypad does however keep a proximity
sensor active to detect if a hand is approach-
ing.
Wait status (WAIT)
When a hand approaches the keypad, only
the ON/OFF symbol is turned on. Activity status (IDLE)
Touch the ON/OFF symbol to “activate” the keypad (IDLE status).
If no further instructions are provided within the next 2 minutes,
the keypad returns to the “wait” status.
The manufacturer will not be held liable in any way should:
- The product not be installed by qualied or authorised sta.
- The installation and maintenance instructions provided in the
manuals not be observed.
- The regulations and legal provisions regarding electrical and
plumbing systems not be abided by.
- The standards referred to in this manual not be observed.
- Uncertied materials be used for installation.
- Incorrect operations be carried out, to the extent that the de-
gree of protection against water sprays is reduced.
- Product components be modied or replaced with respect to
those originally supplied, or should repairs be carried out by
unauthorised sta.
Warnings:
1) Never use or touch electrical appliances when using the show-
er box, even when these appliances are switched o.
2) Electrical appliances positioned in the zones surrounding the
assumption
shower box must be securely xed in position to prevent them
falling into the shower box.
3) Do not leave children alone while using the turkish bath.
4) Do not place animals in the shower box when the turkish bath
is in operation.
5) Do not use the turkish bath during thunderstorms.
6) Pregnant women and very small children should use the ap-
pliance only with the consent of a physician.
7) During Turkish bath usage, take care with the hot steam which
reaches very high temperatures (100°C). Keep your legs at
least 40 cm away from the steam outlet.
8) After use, as with any other household appliance, it is advis-
able to disable the enclosure, ipping the RCBO switch (in-
stalled on the power supply line) to the OFF position.
9) This product is guaranteed as described on the certicate of
warranty.

- 10 -
aromatherapy
123
ESSENTIAL
FIL
TER
ESSENTIAL DIFFUSER
We can add the benets of aromatherapy to that of the Turkish bath.
To make your Turkish bath healthier and more enjoyable, you can add essential oils or
vegetable essences to the steam; these are dispensed using a purpose-designed “diuser”.
To this end, it is advisable to use products that are entirely natural.
VEGETABLE ESSENCES
If on the other hand you have decided to use solid essences, simply pull out the tray from the
diuser and introduce the essences into it, breaking them up into smaller pieces if necessary
to encourage the penetration of steam and achieve better diusion (see the correct sequence
in the gure).
Now you are ready to receive the soft and scented embrace of steam.
essential oil
GB
Caution:
these tasks should always be
performed with the function
disabled.
GB
Caution:
If you use lters, before each
cycle, it is advisable to make
sure there is no residue clog-
ging the steam outlet hole.
BALSAMIC OILS
If you wish to use essential oils, simply pour
a few drops into the purpose-designed tray.
Caution: It is advisable to use a wad of cot-
ton wool (see gure).

- 11 -
boiler maintenance
CLEANING THE BOILER
VAPORISER
In order to benet fully from maximum performance dur-
ing your Turkish bath, it is highly recommended to clean the
steam-generating boiler once a year (or every 30 hours or so
of operation).
To clean the boiler, the following is necessary:
1 - Make sure the appliance is turned o before treatment.
2 - Dilute the bottle of descaler supplied with the shower in
1.5 litres of water.
3 - Pour the solution into the boiler along the duct situated
on the short side of the shower.
N.B. Unscrew the cap and close it.
(see gure)
4 - Allow the solution to rest for approximately 12 hours.
5 - Start the Turkish bath and allow it to run for about 5-8
minutes in order to remove any scale residue from the
boiler.
H2O
l
. 1,5
Descaler
CAUTION:
During operation, always keep the tank cap on completely to avoid harming people and dam-
aging the appliance.
During operation STAY AWAY from the steam dispenser.
warranty
GENERAL WARRANTY
TERMS AND CONDITIONS
The manufacturer guarantees its products for a period of 24 months
from the date of purchase.
The purchase may be proven by a scally valid document issued by
the retailer (till receipt, invoice or delivery slip or warranty slip on the
manual for use) which identies the product purchased and the date of
purchase and/or delivery of the same.
For conformity defects which arise during the rst 6 months of the
product life cycle, the manufacturer undertakes to repair the defect at
no extra charge for the consumer.
From the seventh month to the twenty-fourth month of the warranty
period, in the event of non-ascertained conformity defects, consumers
shall have to pay for the call-out and the manufacturer shall continue
to pay for the labour cost as well as for any functional spare parts used.
On the other hand, in the event of ascertained conformity defects, not
even the cost of the call-out will be charged.
In the event of a dispute, the Court of the user’s place of residence or
domicile shall have jurisdiction.
In the event that the product - purchased in Italy - is installed in a Euro-
pean Union member country, the consumer can get in touch with the
local support reference person by contacting the manufacturer.
After the 24-month warranty period, all repairs shall be paid in full by
the consumer.
The manufacturer will not be held liable for any damage which may -
either directly or indirectly - be caused to property, or personal injury
or harm to animals ensuing from failure to observe all the instructions
provided in the purpose-provided manual and concerning the warn-
ings regarding installation, use and maintenance.
Please note that the manufacturer cannot be held accountable for de-
fects caused by external conditions and/or events such as (by way of
non-exhaustive example):
- insucient capacity of electrical or plumbing systems;
- incorrect installation and/or maintenance carried out by unauthor-
ised sta;
- negligence, inability to use and poor maintenance on the consum-
er’s part, compared to the instructions and recommendations in the
product instruction manual, which is an integral part of the sale con-
tract.
- The same applies for damage caused to the appliance by atmospher-
ic events and natural disasters (lightning, ooding, re, earthquakes,
etc.) or by acts of vandalism, or by circumstances which cannot be
ascribed as manufacturing defects.
The warranty also does not cover:
- actions undertaken to solve problems caused by negligence, acci-
dental breakage, tampering and/or damage during transportation
(scratches, bubbles, dents) when carried out under the consumer’s
responsibility;
- repairs carried out by unauthorised sta;
- actions for operating demonstration, checks and routine mainte-
nance work (including cleaning activities) and everything which was
brought to the consumer’s attention at the time of the sale.

Installation - use
Vapor X9-X15
Code: 0022
Edition 1 (03 - 2019)
The manufacturer has the right to cease production, without
forewarning, of any model and/or to introduce modications
without being obliged to eect the same modications on
products already supplied.
Furthermore, the manufacturers are not answerable for any
transcription or printing errors.