Adaptiv Technologies TPX User manual

TPX™ MAIN CONSOLE
MANUAL
MOTORCYCLE RADAR & LASER
DETECTION SYSTEM

You may register this product online at
www.RadarForBikes.com.

INTRODUCTION
Dear TPX™ Motorcycle Radar and Laser Detection
System Owner,
Congratulations on your purchase of the TPX™ System. This
system is the result of years of research and development by
the motorcycle-minded engineers who started the company.
The system was designed from the ground up with the rider
in mind every step of the way.
The TPX ™ System is not cluttered with unnecessary
features. Its simple and straight forward design allows
you to focus on your ride instead of fiddling with bells and
whistles.
Our goal is to provide you with the highest quality radar and
laser detectors designed specifically for motorcycles. Enjoy
your new TPX ™ System. Enjoy your ride, and ride safe.
Sincerely,
Adaptiv Technologies
2 3

Figure 1b
Release Lever
Wiring Harness Jack
Front Laser Lens
Radar Lens
PRODUCT OVERVIEW
(CONTINUED)
4 5

_
+
Battery
12V D C
Fuse
Red (+) Terminal Ca ble
Black (-) Terminal Cable
LED
Aux O ut
Las er
Mini D IN P lug
Mounting the Main Console
The TPX™ Main Console has a quick release system
that is designed to be compatible with any TPX™ Mount,
Techmount®, or RAM®Mount. If a Techmount®or RAM®
Mount is used, use the adapter plate and hardware included
with the Main Console. If a TPX™ Mount is used, the adapter
plate is not necessary.
Techmount®is a registered trademark of HighGear Specialties, Inc., and RAM®Mount is a
registered trademark of National Products, Inc. Adaptiv Technologies is not affiliated with
HighGear Specialties, Inc. or National Products, Inc.
Aux Out
The connector labeled “Aux Out” provides an additional
audio output signal. This audio signal can be utilized with
any number of communication systems. The connector is
a 3.5mm female mono jack. Contact your communication
system company for appropriate adapter device.
Figure 2
6 7
Wiring Harness Plug
Battery
12V DC
Red (+) Terminal Cable
Fuse
Black (-) Terminal Cable
Visual
Laser
Aux Out

Volume and Brightness Control
Press and hold the button for two or more seconds to toggle
between Volume Control ( ) and Brightness Control
() Modes.
When in Volume Control Mode, the and buttons control
the volume on the Main Console as well as the
optional Wireless Headset.
When in Brightness Control Mode, the and buttons
control the brightness of the flashing LEDs on the optional Visual
Alert.
Warning: The flashing LEDs in the Visual Alert
can be extremely bright, especially at night
time. It can be distracting and dangerous if
you are not familiar with the brightness level.
Before riding with the Visual Alert, especially
at night, take the time to familiarize yourself
with the system in a safe, controlled setting.
The Main Console, the optional Wireless Headset, and the
optional Visual Alert will retain the last volume and brightness
settings each time the power is reset.
Alert Off
Press the button to temporarily disable all alerts
().
When activated, the volume on the Main Console and the
optional Wireless Headset will be muted, and the LEDs of the
optional Visual Alert will not flash. The alerts will be turned off
for the remainder of the existing detected signal and for any
new signal received within 20 seconds of the button press. The
System will automatically turn the alerts back on after this period.
10 11

In response to the individual targeting nature of police
radar guns, any laser signal detected during this period will
override the Alert Off function.
Radar and Laser Signal Detection
When a radar or laser signal is detected, the Main Console
beeps at frequencies according to the detected signal
strength. Slower beeps indicate weak signal detection.
Rapid beeps indicate strong signal detection. Each radar
band or laser signal has its own distinct beep.
The LCD displays the detected radar band or laser signal and
the corresponding signal strength. There are four distinct
radar bands and one laser band as described below:
X band ( ) - The oldest and least common police
radar band. Many automatic door openers and other
nuisance signals use this band. An X band reading has a
high probability of being a false alert. This band is ignored in
City No X Mode. However, a few remaining law enforcement
agencies still use this band, so be careful.
K band ( ) - A common police radar band. There
is a moderate chance of this signal originating from a police
radar gun. Be aware.
Ka band ( ) - The newest and a common police
radar band. There is a very high chance of this signal
originating from a police radar gun. Watch out!
Laser ( ) - Growing in popularity among police
traffic enforcement. There is a very high chance of this
signal originating from a police laser gun. Watch out!
Button Backlights
Press and hold the button for two or more seconds to
toggle the button backlights on/off.
10 11

TROUBLESHOOTING
Problem Possible Causes Possible Solutions
No display or audio
on Main Console
Unit not properly
connected to power
source
Vehicle not turned
on (if connected to
a “switched” power
wire)
Check fuse, replace
with a 250V, 1A fuse
if necessary
Check power
connections
Make sure that plug
is inserted into Main
Conosle properly
Turn vehicle on
Main Console
resets when vehicle
goes over a bump
Poor electrical
connection
Check power
connections
The Main Console
feels very warm
Normal Operation It is normal for the
Main Console to be
warm
The Main Console
did not register
a signal when
driving past a police
vehicle
Police radar is not
turned on
Non-radar or laser
detection methods
are being used
Slow down
12 13
If your TPX™ Main Console is not operating properly, please refer to
the following guide:

Problem Possible Causes Possible Solutions
The Main Console
sensitivity appears
weak
The Main Console
is not mounted
properly
The front and/
or rear of the
Main Console is
obstructed
Check that the Main
Console is mounted
horizontal to the
ground
Check that the front
and rear of the Main
Console are not
obstructed by any
metal or opaque
plastic objects
If using the Main
Console in an
automobile, check
that the detector
is not blocked by
windshield wipers
If using the
Main Console in
an automobile,
determine if
the vehicle has
an Instaclear®,
ElectriClear®, or
solar reflective
windshield,
which may hinder
the detector’s
performance
12 13

14 15
SERVICE
Remove the Main Console from your motorcycle when your
motorcycle is not in operation if it is exposed to an outdoor
environment.
Clean the Main Console with a damp lint-free cloth only. Do
not use any chemicals as they may attack the plastic.
Dry the Main Console with a lint-free cloth after it has been
exposed to moisture.
Warranty Service
If you believe that your TPX ™ Main Console is not
functioning properly, please follow the following procedure:
1. Review the Troubleshooting section.
2. If your problem is not resolved after reviewing the
Troubleshooting section, have your serial number ready and
call us at 646-722-0253. We will try to resolve your problem
over the phone.
3. If your system needs to be returned for repair, we will
provide you with a Service Order Number and a shipping
address. Write the Service Order Number on the outside
of the shipping box. Include the following items in your
shipment:
a. The TPX™ Main Console and Wiring Harness
b. Copy of sales receipt (originals cannot be returned)
c. Your name, phone number, address, and email address
(we promise not to spam)

16 17
All shipment must be sent prepaid by way of a traceable
carrier, such as UPS, FedEx, USPS Priority Mail with
Tracking, etc., and should be insured. Adaptiv Technologies
is not responsible for any loss or damage incurred during
shipping.
Warranty service will only be honored for units purchased
from authorized agents with a copy of the sales receipt.
Repairs will not be performed on units without a readable
serial number.
Please allow 4-8 weeks for the return of the unit.
Non-Warranty Service
For all non-warranty service, follow the same procedure
described in the Warranty Service section and include a
non-refundable payment of $75 for basic diagnostics and
repair. Do not send cash. If there are any additional charges,
we will contact you to discuss your options.
Adaptiv Technologies, LLC warrants to the original purchaser
that the TPX™ Main Console will be free of defects in
workmanship and materials for a period of one year from the
date of first consumer purchase. The TPX™ Main Console
consists of the Main Console assembly, the Wiring Harness,
and the respective parts of each. Adaptiv Technologies
will, at its option, repair or replace a detective TPX™ Main
Console upon delivery to Adaptiv Technologies accompanied
by the original sales receipt or other proof of first consumer
purchase within the warranty period. You are responsible for
WARRANTY

16 17
all charges required to ship the product for warranty service,
but the return charges will be at Adaptiv Technologies’
expense if the product is repaired or replaced under
warranty. This warranty gives you specific rights, and you
may also have other rights which vary from state to state.
EXCLUSIONS: This limited warranty does not apply:
1. To any products sold separately (such as any mount
assemblies);
2. To any defects caused by misuse, abuse, accidents,
modifications, negligence, tampering, or unauthorized
repair;
3. In the State of Virginia, the District of Columbia, or in
any other country or jurisdiction in which possession of
radar detector equipment is illegal;
4. If the serial number label has been altered, defaced, or
removed; or
5. To installation of the unit.
ALL IMPLIED WARRANTIES, INCLUDING IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE ARE LIMITED IN DURANTION TO
THE PERIOD OF THIS WARRANTY*.
* Some states do not allow limitations on the duration of
implied warranties and/or do not allow the exclusion or
limitation of incidental or consequential damages, so the
above limitations may not apply to you.