AED CR-T User manual

Physio-Control
CR-T Quick Start
Guide
Read the Physio-Control CR-T Quick Start Guide for a brief
overview of the device's operation from the manufacturer.
Read about features, specifications, and usage.

©2013 Physio-Control, Inc.
GDR 3308002_B
Physio-Control
Canada Sales, Ltd.
7111 Syntex Drive, 3rd Floor
Mississauga, ON
L5N 8C3
Canada
Toll free 800 895 5896
Fax [phone]
Physio-Control
Headquarters
11811 Willows Road NE
Redmond, WA 98052
www.physio-control.com
Customer Support
P. O. Box 97006
Redmond, WA 98073
Toll free 800 442 1142
Fax [phone]
LIFEPAK®CR-T AED TrAining SySTEm
Setting Up Your CR-T
F1 – SNNN
F2 – SSNN
F3 – NSNN
F4 – NNNN
S=Shock advised
N=No shock advised
Not used for CR-T
Simulates pads are placed correctly and will
move on to analyzing the patient’s heart rhythm
Changes “SHOCK ADVISED” to “NO SHOCK
ADVISED” during analysis
Displays CHARGE-PAKsymbol to simulate need
to replace CHARGE-PAK™battery charger
Simulates low internal battery condition
Simulates a need for service
Simulates motion and will prompt the user to
stop moving the patient during the analysis
Pause
Adjusts volume
Preset Scenarios:
During Training Session:
Please refer to the CR-T Trainer Operating Instructions for
complete directions for use.
C1 – Custom #!:
SSSSSSSSS
C2 – Custom #2:
SSSSSSSSS
Other options:
OP – Sets operating
settings for trainer
T1 – CPR time 1
T2 – CPR time 2
L– Language

Sequence - Shock then No Shock Advised
(Fixed setting #1)
• Press on the remote
• Press F1 ( )
• On the LED display you should see the first bars as
green and the second, third and fourth bars as red
• Press on the remote. It is now set for Shock,
No Shock Advised.
To configure other shock scenarios, go to Page 19 in the
CR-T Operating Instructions.
Set to Fully-Automatic
(no use of shock button) mode
• Press on the remote
• Press OP ( )
• Use to make the first bar in the LED display red
• Press
• Be sure to put plastic cover over shock button
on device
To configure for the semi-automatic setting, go to page 20
in the C R -T Operating Instructions.
For a faster demo, set CPR time to 15 seconds
• Press on the remote
• Press T1 ( )
• Move the red bar in the LED display to the first
position using the button
• Press on the remote
To set other CPR time options, go to page 21 in the CR -T
Operating Instructions.
Tip:
When using the remote, be sure it is within range of the
LED display/IRDA port so it will read commands.
Setting Up Your CR-T
Slide the power switch on the right side of the device forward to turn on device.
OK symbol should now be in the readiness display.
Use the remote control to set your device into the following settings:
LIFEPAK®CR-T AED TrAining SySTEm