AFi ReFrame cube RC040 User manual

www.afibranding.com.au | 1300 652 514 |33 Lakewood Blvd, Carrum Downs, Vic, 3201
Corner Brackets
ReFrame® Lengths
Drill
Screws
8x
12x
24x
1x
1
CHECKLIST
1
RC040 - cube ReFrame®
assembly instructions
Lay out the ReFrame®
components on a flat
surface and ensure you have
everything required before
you start the assembly.
Bridge the two parallel bottom frame lengths to make a
square base
3
2
Repeat step 2 on the remaining 3 corners of the bottom
frame lengths 4
Insert corner bracket into frame length (ensuring the bracket is set in as far as possible)

Connect frames to vertical corner
brackets
Measure and mark 15mm from inside bracket edge
along frame
Fix the corner brackets using a power drill and the
screws provided
Repeat step 7 and 8 on remaining 2 bracket corners Repeat step 8, 9 and 10 on all remaining corners to
complete frame
Repeat step 2, 3 and 4 to make the
top frame
Connect top frame to vertical
lengths
5
8 9
10 11
6 7
15mm
RC040 - cube ReFrame®
assembly instructions
www.afibranding.com.au | 1300 652 514 |33 Lakewood Blvd, Carrum Downs, Vic, 3201
Applying your custom ReFrame® fabric skin
12
Developed by AFI Branding
Now that you’ve finished assembling your ReFrame®, it’s time to apply your custom ReFrame® fabric skin. Please refer to
either a printed ‘ReFrame® Fabric Installation Guide’ or go to www.reframe.com.au to watch one of our instructional
assembly videos to see how to correctly apply your ReFrame® fabric skin.
NOTE: The assembly instructions for the RC040 (and included components) illustrate the fundamental steps to assemble a
‘standard’ Cube type ReFrame®. If your Reframe® is oversize, has additional components such as joiners (not shown on this fact
sheet), accessories, or has bends/curves and you are unsure how to proceed with assembly, please contact the team at AFI
Branding on 1300 652 514 and we will guide you through the assembly process.