Atlas IED AFR Series User manual

AFR Series Atlas Furniture Racks
Install Sheet
©2022 Atlas Sound LP. The Atlas “Circle A”, Soundolier, and Atlas Sound are trademarks of Atlas Sound L.P. IED is a Registered Trademark of Innovative Electronic Designs LLC. All rights reserved. All other Trademarks are property of their respective owners. No endorsement is implied. Due to continual product development, specifications are subject to change without notice. ATS005875 RevB 01/22
AtlasIED.com
TELEPHONE: [phone]
[e-mail]
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Product Features
• Slim profile optimized for mounting in cabinets
• Includes four lacer bars.
Available Options
• AFR16RK: Runner kit for 16" deep AFR
• AFR18RK: Runner kit for 18" deep AFR
• 8RU – 16RU 16" deep
• 8RU – 16RU 18" deep
CAUTION: Place heavier components at the bottom of the enclosure to ensure rack stability. When more than one component is placed in the
enclosure, begin at the bottom of the enclosure and place equipment at the lowest available point, evenly distribute weight (horizontally) within the
enclosure.
Component weight should be distributed as follows:
• 1/2of the total component weight (at a minimum) placed in the bottom third of the cabinet
• 1/4of the total component weight (at a maximum) placed in the middle third of the cabinet
• 1/4of the total component weight (at a maximum) placed in the top third of the cabinet
CAUTION: All installation and assembly steps must be performed by qualified personnel.
CAUTION: Ensure that the floor has a structural load capacity that will support the weight of the cabinet fully loaded with equipment.
CAUTION: Some parts of the enclosure system, such as the lacer bars, may not be effectively bonded to the Protective Earth Terminal (PET). If these
parts need to be bonded to the PET it should be done in accordance with Article 250 of the National Electrical Code.
CAUTION: Power cord(s), for fans or other accessories, need to be secured to ensure that they are routed away from pinch points and moving parts.
CAUTION: Do not attempt to unload or move the enclosures alone. Make sure to have sufficient amount of personnel and equipment to safely move
this product.

AFR Series Atlas Furniture Racks
Install Sheet
©2022 Atlas Sound LP. The Atlas “Circle A”, Soundolier, and Atlas Sound are trademarks of Atlas Sound L.P. IED is a Registered Trademark of Innovative Electronic Designs LLC. All rights reserved. All other Trademarks are property of their respective owners. No endorsement is implied. Due to continual product development, specifications are subject to change without notice. ATS005875 RevB 01/22
AtlasIED.com
TELEPHONE: [phone]
[e-mail]
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Install Rails to top and bottom through the holes shown using the supplied hardware.
Install the screws and nuts as shown. The top and bottom of the AFR Enclosure are interchangeable.
Install the lacing bars to the rack rail holes at selected height using the supplied hardware.
Install the runners (optional accessory AFR16RK or AFR181RK) to the enclosure bottom through the holes shown using the supplied hardware.