AG Neovo WMK-01 User manual

English
1
Package Contents
Before starting wall mount kit installation, be sure that the following
items are contained in the box.
 Display Bracket (x1)  Wall Bracket (x1)
 Screw A*：M4-8mm (x4)  Screw B*：M4-15mm (x4)
* Suitable for other AG Neovo
displays
* Only for M - Series
 Screw C*：M4-18mm (x2)
* Only for S-15E
 Screw D：4-19mm (x4)  Wall anchor：1/4”-1” (x4)
 Quick Guide (x1)

English
2
Precautions
• Install your display and wall mount kit on the wall with a flat
surface.
• Be sure the wall can support the weight of a display
weighing up to 18kgs (40 lbs).
• Use only the provided materials and follow the step-by-step
instructions to finish the installation.
Applicable LCD Display Models
This wall mount kit complies with VESA’s (Video Electronics
Standards Association) FPMPMI (Flat Panel Display Physical
Mounting Interface) Standard. All AG Neovo displays are suitable for
this wall mount kit.
Tools you will need
You may need the following tools to complete wall mount
installations.
• Phillips head screwdriver
• Drill with 1/4” (6.35mm) bit (only if you want to install your
display on a concrete wall.)

English
3
Setup
Please follow the steps one by one to mount your display on the
wall.
Step 1: Installing the Wall Bracket onto the Wall
Consult with appropriate engineering or construction
personnel to ensure the wall mount kit is mounted
properly to handle applied loads.
Depending on the material and
construction of the wall, different
types of screws and tools will be
needed to complete this part of
the installation.
 For a wooden wall, you may mount the Wall Bracket to it by
using screw D directly.
 For a concrete wall, you need to drill four 1 1/2” (38.1mm) deep
holes, insert the 4 wall anchors into the holes accordingly. Then
you can use screws D to fix the Wall Bracket to the wall.
 The arrow sign on the metal plate should point upwards.

English
4
Step 2: Installing the Display Bracket to the rear of the LCD
display
75mm
100mm
Use screw A、B or screw C to secure Display Bracket to the rear of
display. Line up the holes of the Bracket with the holes in the rear of
the display. (The Bracket supports both 75mm and 100mm VESA
standards.)
Step 3: Connect all the cables before attaching display to wall
It is difficult to connect cables after hanging the display on the wall.
Step 4: Hang the display on the Wall Bracket
The cables should pass through the space between the two Brackets
for better cable management.